Installation Guide

Step 1. Install the latch
• Insert the latch into 1″ hole on edge of the
door.
• Secure the latch in place with two screws.
Fig. 1
Step 2. Install outside lock housing
• Place the outside gasket (if required) on back of the
outside lock housing prior to the assembly; align the
gasket along the edge of the lock housing.
• Insert the square spindle into the center hub and turn
the spindle until it locks. Ensure that the Dot on
center hub is point to left.
• Place the outside lock
housing against the door,
feed the power plug
through the 2 1/8″ door
hole.
Fig. 3
Step 3. Install inside mounting plate
• Place the inside gasket (if required) on the
mounting plate, and align the inside
gasket with the position hole.
• Feed the power plug through the
small hole on the mounting plate.
• Place the mounting plate against the
door, and secure the mounting plate
attach to outside lock housing with
three screws.
Fig. 4
Step 4. Install inside lock housing
• Plug the power cable into the
inside lock housing.
• Place inside lock housing on
top of the mounting plate,
• Ensure the square spindle into
inside lever hub. Secure the
inside lock housing with two
screws.
Fig. 5
Step 5. Install inside lever door handle.
Fig. 6
Step 6. Install outside lever door handle
• Ensure override shaft inside the
cylinder housing is in vertical position
(use flat screw driver to adjust the
position when needed)
Fig. 7
• Place the key cylinder into the outside
lever door handle, insert the manual
key to the cylinder and turn clockwise
90 degrees.
• Guide the cylinder into the cylinder
housing and snap the lever door
handle into the lever catch pin
• Turn the manual key counter
clockwise 90 degree and pull the key
out
Step 7. Install Strike plate
• Inset the dust boot into the
doorframe.
• Place the strike plate over
the dust boot.
• Secure the plate in place
with two screws.
Fig. 8
ResortLock Installation Instructions
ww.ResortLock.com