User's Manual

When installed the LocoTrack Primary is placed inside or onto an asset and turned on.
For both variants, the device will only be handled by human operators when it is installed and
when it is removed from an asset. After it is removed, the device is switched off and (typically)
recycled.
HGD4
The LocoTrack Primary can be configured to operate in different ways. The device wakes up
periodically to perform operations. Between operations the device's radios are asleep.
In the expected use case for the HGD4 the operating cycle will be as follows:
When the device is stationary, every four hours the device will wake up, perform radio operations
and go back to sleep. The on-time is usually 1 minute. The moving state is used when the device
is packaged inside a shipment of goods and is in transit by sea, air or ground (during which
periods, the device is not handled).
HGP4
In the expected use case for the HGP4 the operating cycle will be as follows:
The device will wake up once every 24 hours, perform radio operations and go back to sleep.
The on-time is usually 1 minute.
HGC4
The HGC4 operating cycle is the same as the HGP4