Safety Data Sheet according to Regulation (EC) No 1907/2006 Page 1 of 13 SDS No. : 173255 V003.4 Revision: 23.07.2019 printing date: 14.08.2019 Replaces version from: 14.06.2017 LOCTITE 4062 SECTION 1: Identification of the substance/mixture and of the company/undertaking 1.1. Product identifier LOCTITE 4062 1.2. Relevant identified uses of the substance or mixture and uses advised against Intended use: Adhesive 1.3.
SDS No.: 173255 V003.4 LOCTITE 4062 Page 2 of 13 Signal word: Warning Hazard statement: H315 Causes skin irritation. H319 Causes serious eye irritation. H335 May cause respiratory irritation. Supplemental information EUH202 Cyanoacrylate. Danger. Bonds skin and eyes in seconds. Keep out of the reach of children. Precautionary statement: Prevention P261 Avoid breathing vapors. P280 Wear protective gloves/eye protection.
SDS No.: 173255 V003.4 LOCTITE 4062 Page 3 of 13 Inhalation: Move to fresh air, consult doctor if complaint persists. Skin contact: Do not pull bonded skin apart. It may be gently peeled apart using a blunt object such as a spoon, preferably after soaking in warm soapy water. Cyanoacrylates give off heat on solidification. In rare cases a large drop will generate enough heat to cause a burn. Burns should be treated normally after the adhesive has been removed from the skin.
SDS No.: 173255 V003.4 LOCTITE 4062 Page 4 of 13 6.3. Methods and material for containment and cleaning up Do not use cloths for mopping up. Flood with water to complete polymerization and scrape off the floor. Cured material can be disposed of as non-hazardous waste. Dispose of contaminated material as waste according to Section 13. 6.4. Reference to other sections See advice in section 8 SECTION 7: Handling and storage 7.1.
SDS No.: 173255 V003.
SDS No.: 173255 V003.4 LOCTITE 4062 Page 6 of 13 Hand protection: Chemical-resistant protective gloves (EN 374). Suitable materials for short-term contact or splashes (recommended: at least protection index 2, corresponding to > 30 minutes permeation time as per EN 374): nitrile rubber (NBR; >= 0.4 mm thickness) Suitable materials for longer, direct contact (recommended: protection index 6, corresponding to > 480 minutes permeation time as per EN 374): nitrile rubber (NBR; >= 0.
SDS No.: 173255 V003.4 LOCTITE 4062 Page 7 of 13 Viscosity (kinematic) Explosive properties Oxidising properties No data available / Not applicable No data available / Not applicable No data available / Not applicable 9.2. Other information No data available / Not applicable SECTION 10: Stability and reactivity 10.1. Reactivity Rapid exothermic polymerization will occur in the presence of water, amines, alkalis and alcohols. 10.2. Chemical stability Stable under recommended storage conditions. 10.3.
SDS No.: 173255 V003.4 LOCTITE 4062 Page 8 of 13 Acute inhalative toxicity: No data available. Skin corrosion/irritation: Bonds skin in seconds. Considered to be of low toxicity: acute dermal LD50 (rabbit)>2000mg/kg Due to polymerisation at the skin surface allergic reaction is unlikely to occur Hazardous substances CAS-No.
SDS No.: 173255 V003.4 LOCTITE 4062 Page 9 of 13 Germ cell mutagenicity: The mixture is classified based on threshold limits referring to the classified substances present in the mixture. Hazardous substances CAS-No. Result Type of study / Route of administration bacterial reverse mutation assay (e.g Ames test) mammalian cell gene mutation assay Metabolic activation / Exposure time in vitro mammalian chromosome aberration test bacterial reverse mutation assay (e.
SDS No.: 173255 V003.4 LOCTITE 4062 Page 10 of 13 STOT-single exposure: No data available. STOT-repeated exposure:: The mixture is classified based on threshold limits referring to the classified substances present in the mixture. Hazardous substances CAS-No.
SDS No.: 173255 V003.4 LOCTITE 4062 Page 11 of 13 The mixture is classified based on calculation method referring to the classified substances present in the mixture. Hazardous substances CAS-No.
SDS No.: 173255 V003.4 LOCTITE 4062 Page 12 of 13 Product disposal: Cured adhesive: Dispose of as water insoluble non-toxic solid chemical in authorised landfill or incinerate under controlled conditions. Dispose of in accordance with local and national regulations.
SDS No.: 173255 V003.4 LOCTITE 4062 RID ADN IMDG IATA 14.7. Page 13 of 13 not applicable not applicable not applicable Primary packs containing less than 500ml are unregulated by this mode of transport and may be shipped unrestricted. Transport in bulk according to Annex II of Marpol and the IBC Code not applicable SECTION 15: Regulatory information 15.1. Safety, health and environmental regulations/legislation specific for the substance or mixture VOC content <3% (2010/75/EC) 15.2.
