Safety Data Sheet according to Regulation (EC) No 1907/2006 Page 1 of 12 SDS No. : 153535 V003.5 Revision: 04.04.2018 printing date: 12.02.2020 Replaces version from: 30.03.2017 LOCTITE 420 SECTION 1: Identification of the substance/mixture and of the company/undertaking 1.1. Product identifier LOCTITE 420 Contains: Ethyl 2-cyanoacrylate 1.2. Relevant identified uses of the substance or mixture and uses advised against Intended use: Adhesive 1.3.
SDS No.: 153535 V003.5 LOCTITE 420 Page 2 of 12 Signal word: Warning Hazard statement: H315 Causes skin irritation. H319 Causes serious eye irritation. H335 May cause respiratory irritation. Supplemental information EUH202 Cyanoacrylate. Danger. Bonds skin and eyes in seconds. Keep out of the reach of children. Precautionary statement: Prevention P261 Avoid breathing vapours. P280 Wear protective gloves/eye protection.
SDS No.: 153535 V003.5 LOCTITE 420 Page 3 of 12 Inhalation: Move to fresh air, consult doctor if complaint persists. Skin contact: Do not pull bonded skin apart. It may be gently peeled apart using a blunt object such as a spoon, preferably after soaking in warm soapy water. Cyanoacrylates give off heat on solidification. In rare cases a large drop will generate enough heat to cause a burn. Burns should be treated normally after the adhesive has been removed from the skin.
SDS No.: 153535 V003.5 LOCTITE 420 Page 4 of 12 6.3. Methods and material for containment and cleaning up Do not use cloths for mopping up. Flood with water to complete polymerization and scrape off the floor. Cured material can be disposed of as non-hazardous waste. 6.4. Reference to other sections See advice in section 8 SECTION 7: Handling and storage 7.1.
SDS No.: 153535 V003.
SDS No.: 153535 V003.5 LOCTITE 420 Page 6 of 12 Respiratory protection: Ensure adequate ventilation. An approved mask or respirator fitted with an organic vapour cartridge should be worn if the product is used in a poorly ventilated area Filter type: A (EN 14387) Hand protection: Chemical-resistant protective gloves (EN 374).
SDS No.: 153535 V003.5 LOCTITE 420 Bulk density Solubility Solubility (qualitative) (Solvent: Water) Solubility (qualitative) (Solvent: Acetone) Partition coefficient: n-octanol/water Auto-ignition temperature Decomposition temperature Viscosity Viscosity (kinematic) Explosive properties Oxidising properties Page 7 of 12 No data available / Not applicable No data available / Not applicable Polymerises in presence of water.
SDS No.: 153535 V003.5 LOCTITE 420 Page 8 of 12 Acute dermal toxicity: The mixture is classified based on calculation method referring to the classified substances present in the mixture. Hazardous substances CAS-No. Ethyl 2-cyanoacrylate 7085-85-0 Value type LD50 Value > 2.000 mg/kg Species Method rabbit OECD Guideline 402 (Acute Dermal Toxicity) Acute inhalative toxicity: No data available. Skin corrosion/irritation: Bonds skin in seconds.
SDS No.: 153535 V003.5 LOCTITE 420 Page 9 of 12 Reproductive toxicity: No data available. STOT-single exposure: No data available. STOT-repeated exposure:: The mixture is classified based on threshold limits referring to the classified substances present in the mixture. Hazardous substances CAS-No. Hydroquinone 123-31-9 Result / Value Route of application NOAEL >= 250 mg/kg oral: gavage Exposure time / Frequency of treatment 14 days 5 days/week.
SDS No.: 153535 V003.5 LOCTITE 420 Page 10 of 12 The mixture is classified based on calculation method referring to the classified substances present in the mixture. Hazardous substances CAS-No.
SDS No.: 153535 V003.5 LOCTITE 420 Page 11 of 12 Product disposal: Cured adhesive: Dispose of as water insoluble non-toxic solid chemical in authorised landfill or incinerate under controlled conditions. Dispose of in accordance with local and national regulations.
SDS No.: 153535 V003.5 LOCTITE 420 RID ADN IMDG IATA 14.7. Page 12 of 12 not applicable not applicable not applicable Primary packs containing less than 500ml are unregulated by this mode of transport and may be shipped unrestricted. Transport in bulk according to Annex II of Marpol and the IBC Code not applicable SECTION 15: Regulatory information 15.1. Safety, health and environmental regulations/legislation specific for the substance or mixture VOC content < 3,00 % (2010/75/EC) 15.2.
