Instructions / Assembly

Revision: April 26, 2018
Supersedes: August 30, 2016
Ref. #: 248643 / 352971
TECHNICAL DATA SHEET
Loctite® Epoxy Plastic
Page 2 of 3
Typical Cured Performance Properties
Color:
Translucent Yellow
Cured form:
Non-flammable, hard, solid.
Paintable:
No
Water Resistant:
Yes
Hardness:
80 (+/-1), Shore D
Sandable:
Yes
Service Temperature:
-10°F(-23°C) to 120°F (49°C)
-10°F(-23°C) to 302°F (150°C)
Long term exposure
Short term exposure
Test Methods
Cure Time
Data
Substrates
Compressive Shear
Strength:
24 hour cure
1081 ± 199 psi (7.45 ± 1.37 N/mm²)
958 ± 268 psi (6.61 ± 1.85 N/mm²)
Sanded, Hard PVC (White)
Sanded, Acrylite FF
Tools Typically Required
Utility knife, mixing tool/applicator (e.g. small flat plastic or wooden stick), disposable surface (e.g. foil).
Safety Precautions:
Apply and cure in a well-ventilated area. Wear gloves and wash hands after use.
Preparation:
Surfaces must be clean, dry and free from oil, wax, paint, rust, etc. Roughen smooth surfaces for better adhesion by sandblasting or sanding
with an emery cloth. Wash glass and ceramic surfaces with soap and water then rinse and let dry. Pre-fit parts to be joined. Remove the plug
from between the piston. Cut off the end tips of the syringe at one of the three cut-off points as illustrated below. For easier extrusion, cut at
the 4 mm or 5mm opening. For more precise application, cut at 3 mm opening.
Turn syringe dispensing end up and pull plunger back slightly allowing air bubbles to rise to top. Take care to not exert excessive pressure or
plunger may pull out of syringes. Press the plunger to expel air. Depress the double piston to dispense equal parts of the two materials on a
disposable surface. Mix resin and hardener thoroughly (about 1 minute). Wipe syringe tips clean, retract piston slightly and close with the
plug. Ensure that the plug is always placed in the same orientation on the tips.
Application: Apply a small amount of mixed adhesive to both surfaces, within one or two minutes of mixing and press together. Placing
parts together close to the 5 minute set time will reduce adhesion. Remove any excess glue immediately by wiping with acetone. Support
bond for at least 10 minutes at room temperature. Usable strength achieved in 1 hour. Full cure and strength in 24 hours.
Clean-up: Clean excess glue immediately with acetone before adhesive sets. Cured adhesive may be cut away with caution using a sharp
blade. Prolonged immersion in paint stripper will soften the cured adhesive to aid removal. Note: Acetone is highly flammable and not
compatible with all surfaces. Follow manufacturer’s instructions and test on small area before applying.
Not damaged by freezing. If frozen, warm to room temperature until the resin and hardener become liquid enough to mix. Use an approved
hazardous waste facility for disposal.
STORAGE AND DISPOSAL
DIRECTIONS:
TECHNICAL DATA: