Installation Instructions

Tools Typically Required:
Utility knife (for syringe)
Safety Precautions:
Apply and cure in a well-ventilated area. Wear gloves and wash hands after use.
Preparation:
Protect work area. Surfaces must be clean, dry and free from oil, wax and paint. Roughen smooth surfaces for better adhesion by
sandblasting or sanding with an emery cloth. Wash glass and ceramic surfaces with soap and water then rinse and let dry. Pre-fit
parts to be joined. Hold syringe with nozzle end up and pull plunger back slightly allowing air bubbles to rise to top. Snap cap off by
pushing to the side (do not twist) and discard. Attach nozzle over syringe opening, push past prongs and turn 90° to lock in place.
Application:
Depress plunger to dispense epoxy directly onto one side of the surfaces to be bonded. Wipe syringe tip immediately. Join surfaces
within 4 minutes of adhesive application. Immediately remove excess glue using mineral spirits or rubbing alcohol (follow
manufacturer’s instructions). Bond sets in about 5-7 minutes at 68°F (20°C) to 77°F (25°C). For best results in butt joints, apply
adhesive as a reinforcing filet or splint for additional support. Usable strength is obtained within 20 minutes. Warmer temperatures
will shorten the set time and cooler temperatures will lengthen it.
Clean-up:
Remove and discard nozzle. Retract plunger slightly and wipe syringe tip. Remove cap from side holder and place on end of
syringe. Clean excess glue immediately by wiping with clean cloth. Acetone may be used to assist in removal. Cured adhesive may
be cut away with caution using a sharp blade. Prolonged immersion in paint stripper will soften the cured adhesive to aid removal.
Note: Acetone is highly flammable and not compatible with all surfaces. Follow manufacturer’s instructions and test on small area
before applying.