Installation Instructions

Tools Typically Required:
Utility knife, mixing tool/applicator (e.g. small flat plastic or wooden stick), discardable surface (e.g. foil).
Safety Precautions:
Well-ventilated area, gloves.
Preparation:
Surfaces must be clean, dry and free from oil, wax and paint. Roughen smooth surfaces for better adhesion by sandblasting or
sanding with an emery cloth. Wash glass and ceramic surfaces with soap and water then rinse and let dry. Pre-fit all parts to be
joined. Remove the plug from between the piston. Cut off the end tips of the syringe. Turn nozzle end up and pull plunger back
slightly allowing air bubbles to rise to top. Press plunger to expel air. Depress the double piston to dispense equal parts of the two
materials on a discardable surface. Mix resin and hardener thoroughly. Wipe syringe tips clean, retract piston slightly and close with
the plug. Ensure that the plug is always placed in the same orientation on the tips.
Application:
Apply a small amount of mixed adhesive to both surfaces, join and press together. Remove any excess glue immediately by wiping
with acetone. Support until bond sets in about 6 minutes at room temperature. Support until bond sets in about 6 minutes at room
temperature. For best results, clamp or secure as required for 1 hour. Usable strength in 8 hours. Moderate heat will speed
hardening while cooler temperatures will require a longer set time.
Clean-up:
Clean excess glue immediately with mineral spirits or acetone. Cured adhesive may be cut away with caution using a sharp blade.
Prolonged immersion in paint stripper will soften the cured adhesive to aid removal. Note: Acetone is highly flammable and not
compatible with all surfaces. Follow manufacturer’s instructions and test on small area before applying.