Installation Instructions

Tools Typically Required:
Utility knife, mixing tool/applicator (e.g. small flat plastic or wooden stick), disposable surface (e.g. foil, paper).
Safety Precautions:
Well-ventilated area, gloves.
Preparation:
Surfaces must be clean and free from oil, wax and paint. Roughen smooth surfaces for better adhesion by sandblasting or sanding
with emery cloth. Wash glass and ceramic surfaces with soap and water then rinse and let dry. Pre-fit parts to be joined. Remove
the plug from between the piston. Cut off the end tips of the syringe. Turn syringe end up and pull plunger back slightly allowing air
bubbles to rise to top. Press plunger to expel air. Depress the double piston to dispense equal parts of the two materials on a
disposable surface. Wipe syringe tips clean, retract piston slightly and close with the plug. Ensure that the plug is always placed in
the same orientation on the tips. Mix resin and hardener for one minute thoroughly.
Application:
Apply a small amount of mixed adhesive to both surfaces and assemble parts together. Remove any excess glue immediately with
acetone. Support parts until bond sets (approx. 120-150 minutes at room temperature). Allow full cure of 24 hours before subjecting
to normal use.
Clean-up:
Clean excess glue immediately by wiping with clean cloth. Acetone, mineral spirits or rubbing alcohol may be used to assist in
removal. Cured adhesive may be cut away with caution using a sharp blade. Prolonged immersion in paint stripper will soften the
cured adhesive to aid removal. Note: Acetone is highly flammable and not compatible with all surfaces. Follow manufacturer’s
instructions and test on small area before applying.