Installation Instructions

Tools Typically Required
Kraft paper or other material to protect surrounding area.
Safety Precautions:
Apply in a well-ventilated area, wash hands after use.
Preparation:
The adhesive and materials should be between 65°F (18°C) and 95°F (35°C). Shake can well before using (approximately 10 – 12
times). Surfaces must be clean, dry and free of foreign materials. Protect finished surfaces. Pre-fit all materials. Test substrates for
compatibility before starting application.
Application:
Turn spray tip so that the black dot is aligned with the nozzle. Hold can in a vertical position. Point valve towards surface and spray
from a distance of 8” to 10” (20 to 25 cm). Keep the can moving to create an even coat and avoid build-up on the surface. Start and
stop the spray just off the work to prevent runs and sags.
For repositionable / temporary bonds: Apply a very light even coat to one surface. After 15 seconds, join with light pressure only. To
remove, gently peel from corner.
For stronger permanent bonds: Apply a medium coat to both surfaces. Allow to dry to tack (1 to 10 minutes) and join. Porous
surfaces will require more than one coat. Porous surfaces may be bonded while still wet.
Clean-up:
After use, invert spray can and spray for approximately 2 seconds (or until spray is free of adhesive) to clear valve and spray tip.
Clean spray tip with turpentine or mineral spirits. Note: When using solvents for cleanup, use proper precautionary measure.