SDS

ManualsBrandsLoctite ManualsPaint28 fl. oz. PL 500 Landscape Block Adhesive

Safety Data Sheet

Revision Number: 002.1

Issue date: 06/06/2018

IDH number: 1602122

Product name: Loctite PL Landscape Block Adhesive

Page 1 of 8

1. PRODUCT AND COMPANY IDENTIFICATION

Product name:

Loctite PL Landscape Block Adhesive

IDH number:

1602122

Product type:

Assembly adhesive, solvent

Restriction of Use:

None identified

Region:

United States

Company address:

Contact information:

Henkel Corporation

One Henkel Way

Rocky Hill, Connecticut 06067

Telephone: (860) 571-5100

MEDICAL EMERGENCY Phone: Poison Control Center

1-877-671-4608 (toll free) or 1-303-592-1711

TRANSPORT EMERGENCY Phone: CHEMTREC

1-800-424-9300 (toll free) or 1-703-527-3887

Internet: www.henkelna.com

2. HAZARDS IDENTIFICATION

EMERGENCY OVERVIEW

DANGER:

HIGHLY FLAMMABLE LIQUID AND VAPOR.

CAUSES SERIOUS EYE IRRITATION.

MAY CAUSE DROWSINESS OR DIZZINESS.

HAZARD CLASS

HAZARD CATEGORY

FLAMMABLE LIQUID

EYE IRRITATION

SPECIFIC TARGET ORGAN TOXICITY - SINGLE EXPOSURE

PICTOGRAM(S)

Precautionary Statements

Prevention:

Keep away from heat, sparks, open flames, hot surfaces - no smoking. Keep container tightly

closed. No release into water. Use explosion-proof equipment. Use non-sparking tools. Take

action to prevent static discharges. Avoid breathing vapors, mist, or spray. Wash affected area

thoroughly after handling. Use only outdoors or in a well-ventilated area. Wear protective

gloves, eye protection, and face protection.

Response:

If on skin (or hair): Take off immediately all contaminated clothing. IF INHALED: Remove victim

to fresh air and keep at rest in a position comfortable for breathing. Call a POISON CENTER or

physician if you feel unwell. IF IN EYES: Rinse cautiously with water for several minutes.

Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists:

Get medical attention. In case of fire: Use foam, dry chemical or carbon dioxide to extinguish.

Storage:

Store in a well-ventilated place. Keep container tightly closed. Store in a well-ventilated place.

Keep cool. Store locked up.

Disposal:

Dispose of contents and/or container according to Federal, State/Provincial and local

governmental regulations.

Classification complies with OSHA Hazard Communication Standard (29 CFR 1910.1200) and is consistent with the provisions of the

United Nations Globally Harmonized System of Classification and Labeling of Chemicals (GHS).

See Section 11 for additional toxicological information.

Summary of content (8 pages)

PAGE 1
Safety Data Sheet Revision Number: 002.1 Issue date: 06/06/2018 1.
PAGE 2
3. COMPOSITION / INFORMATION ON INGREDIENTS Hazardous Component(s) CAS Number Percentage* Limestone Acetone Kaolin Petroleum resins Rosin ester Methyl acetate Titanium dioxide Quartz (SiO2), <1% respirable 1317-65-3 67-64-1 1332-58-7 64742-16-1 Proprietary 79-20-9 13463-67-7 14808-60-7 30 - 40 10 - 20 10 - 20 1-5 1-5 1-5 0.1 - 1 0.1 - 1 * Exact percentages may vary or are trade secret. Concentration range is provided to assist users in providing appropriate protections. 4.
PAGE 3
Clean-up methods: Use noncombustible absorbent material such as sand. Use non-sparking tools for clean-up. Absorb spill with inert material. Shovel material into appropriate container for disposal. Dispose of according to Federal, State and local governmental regulations. 7. HANDLING AND STORAGE Handling: Do not pressurize, cut, heat or weld containers. Empty product containers may contain product residue. Do not reuse empty containers. Use only in well-ventilated areas.
PAGE 4
8. EXPOSURE CONTROLS / PERSONAL PROTECTION Employers should complete an assessment of all workplaces to determine the need for, and selection of, proper exposure controls and protective equipment for each task performed. Hazardous Component(s) Limestone Acetone Kaolin Petroleum resins Rosin ester Methyl acetate Titanium dioxide Quartz (SiO2), <1% respirable ACGIH TLV OSHA PEL 10 mg/m3 TWA Total dust. 250 ppm TWA 500 ppm STEL 2 mg/m3 TWA Respirable fraction.
PAGE 5
9. PHYSICAL AND CHEMICAL PROPERTIES Physical state: Color: Odor: Odor threshold: pH: Vapor pressure: Boiling point/range: Melting point/ range: Specific gravity: Vapor density: Flash point: Flammable/Explosive limits - lower: Flammable/Explosive limits - upper: Autoignition temperature: Flammability: Evaporation rate: Solubility in water: Partition coefficient (n-octanol/water): VOC content: Viscosity: Decomposition temperature: Liquid Light tan Acetone Not available. 7 Not available. 56 - 57 °C (132.
PAGE 6
Potential Health Effects/Symptoms Inhalation: Skin contact: Eye contact: Ingestion: Hazardous Component(s) Limestone Acetone Kaolin Petroleum resins Rosin ester Methyl acetate May cause nose, throat and lung irritation. Abrasion of cured material such as by sanding or grinding could release respirable particles of silica quartz, a cancer hazard by inhalation. Normal use of this product causes no such release. Causes skin irritation. Causes serious eye irritation. May be harmful if swallowed.
PAGE 7
13. DISPOSAL CONSIDERATIONS Information provided is for unused product only. Recommended method of disposal: Dispose of according to Federal, State and local governmental regulations. Hazardous waste number: D018: Benzene. It is the responsibility of the user to determine if an item is hazardous as defined in the Resource Conservation and Recovery Act (RCRA) at the time of disposal. Product uses, transformations, mixtures, processes, etc.
PAGE 8
16. OTHER INFORMATION This safety data sheet contains changes from the previous version in sections: This Safety Data Sheet contains changes from the previous version in Section(s): 2, 3, 8, 11, 15, 16 Prepared by: Product Safety and Regulatory Affairs Issue date: 06/06/2018 DISCLAIMER: The data contained herein are furnished for information only and are believed to be reliable.