SDS
IDH number: 1602122
Product name: Loctite PL Landscape Block Adhesive
Page 2 of 8
3. COMPOSITION / INFORMATION ON INGREDIENTS
Hazardous Component(s)
CAS Number
Percentage*
Limestone
1317-65-3
30 - 40
Acetone
67-64-1
10 - 20
Kaolin
1332-58-7
10 - 20
Petroleum resins
64742-16-1
1 - 5
Rosin ester
Proprietary
1 - 5
Methyl acetate
79-20-9
1 - 5
Titanium dioxide
13463-67-7
0.1 - 1
Quartz (SiO2), <1% respirable
14808-60-7
0.1 - 1
* Exact percentages may vary or are trade secret. Concentration range is provided to assist users in providing appropriate protections.
4. FIRST AID MEASURES
Inhalation:
If inhaled, immediately remove the affected person to fresh air. If breathing is
difficult, give oxygen. If not breathing, give artificial respiration. If symptoms
develop and persist, get medical attention.
Skin contact:
Immediately wash skin thoroughly with soap and water. If symptoms develop
and persist, get medical attention.
Eye contact:
In case of contact with the eyes, rinse immediately with plenty of water for 15
minutes, and seek immediate medical attention.
Ingestion:
Do not induce vomiting, seek medical advice immediately.
Symptoms:
See Section 11.
Notes to physician:
Treat symptomatically and supportively.
5. FIRE FIGHTING MEASURES
Extinguishing media:
Foam, dry chemical or carbon dioxide. In case of fire, keep containers cool
with water spray.
Special firefighting procedures:
Wear a self-contained breathing apparatus with a full face piece operated in
pressure-demand or other positive pressure mode. Wear full protective
clothing.
Unusual fire or explosion hazards:
Closed containers may explode when exposed to extreme heat. Vapors may
form explosive mixtures with air. Vapors are heavier than air and may travel
along floor to an ignition source.
Hazardous combustion products:
Upon decomposition, this product emits carbon monoxide, carbon dioxide
and/or low molecular weight hydrocarbons.
6. ACCIDENTAL RELEASE MEASURES
Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and unprotected
personnel.
Environmental precautions:
Eliminate all sources of ignition or flammables that may come into contact with
a spill of this material. Ventilate area. Wear appropriate protective equipment
and clothing during clean-up. Prevent further leakage or spillage if safe to do
so. Do not allow product to enter sewer or waterways.