Installation Guide

LoctiteTITEFOAMInsulatingFoamSealantInstallationGuide
1.Thisproductisextremelyflammable.Donotusenearsparks,heatoropenflame.Vaporswill
accumulatereadilyandmayigniteexplosively.Donotsmokeorusematches/lighterswhiledispensing
foam.Areashouldbewell‐ventilated.
2.Alwaysweareyeprotection,glovesandproperworkclotheswhenusingLoctiteTITE
FOAM.Cured
foamisdifficulttoremovefromskinandclothingandmaydiscolorskin.
3.Ensureallsurfacesarecleanandfreefromdirt,dust,oilandothercontaminantslikelytoimpair
adhesion.Surfacescanbemoistbutnotfrostedoriced.Coversurfacesnotintendedtobefoamed.
4.Forporous,mineralsubstrates(ie.brickwork,concrete),slightlydampen surfaces withwaterspray
beforeapplication.
5.Temperatureoftheworkingareashouldbebetween
23°F(‐5°C)and95°F(35°C).Temperatureofthe
productshouldbebetween41°F(5°C)and86°F(30°C).Whenworkingincoldconditions,canshouldbe
storedatroomtemperatureforatleast12hoursbeforeuse.
6.Shakecanvigorouslyforatleast30secondsbeforeuse.
7.Screwstraw
intovalve.
8.Holdingcanupsidedown,pressthetriggerwhichcontrols theoutflowrateoffoam.Dispense
sparingly,fillingthejointinitiallybyhalftoavoidexcessiveoverflow.Shakecanregularlyduringuse.
9.Slightmistingwithwatercanspeedcure.Foamcanbetrimmedwithaknifeafter
anhourandwillbe
fullycuredinapproximately24hours.
9.Cleantoolsanduncuredfoamresidueusingacetone.Curedfoammustberemovedmechanically.
Otherusefultips:
ItisrecommendedfoambeprotectedfromUVradiationbyaprotectivecoveringorcoatingsuchas
paint,plaster,mortar,etc.
Ambienttemperatureandhumiditycanaffectfoamcuringandmaximaljointwidth.Indryconditions,to
getthebestfoamstructureandproperties,itisrecommendedto
fillgapsandjointsinseverallayersby
theapplicationofsmallerfoamstrings(upto2inchesthickness).
Atverydryconditions,thefoammaybebrittleafterhardening.Thisbrittlenessisatemporaryeffect.

