Installation Instructions

Tools Typically Required:
Tissue paper
Safety Precautions:
Use in a well-ventilated area. Protect work area. Wash hands after use.
Preparation:
Surfaces to be bonded must be close fitting, clean, dry and free from oil, wax and paint. Protect work area. For best results, lightly
roughen smooth surfaces. Pre-fit parts to be joined. To puncture nozzle, turn cap clockwise until clicking sound stops. Unscrew cap
counterclockwise.
Application:
Squeeze side grips for precision dispensing. Apply sparingly to one surface - only one drop of adhesive per square inch of surface is
required. Press parts together immediately and hold for at least 15-30 seconds. Do not attempt to reposition the parts. Immediately
after use, clean tip with tissue and replace cap. For increased strength, leave the parts undisturbed for at least 5 minutes. Full cure
in 24 hours. Note: Cure time is dependent upon temperature, humidity, porosity of surfaces and amount of adhesive applied.
Clean-up:
To ensure non-clog tip, simply wipe with tissue and snap cap on container for safe storing. After cleaning, wet any tissue used for
wiping off glue with water and dispose of. When cleaning up larger quantities of uncured adhesive, apply water and allow to cure
and then scrape up. Note this may result in damage to the surfaces. Cured adhesive may be cut away with caution using a sharp
blade, removed with acetone or with boiling water. Note: Acetone is highly flammable and may not be suitable for use on all
materials, test surface first. Follow manufacturer’s instructions.