Specification

IDH number: 2066118
Product name: Loctite Super Glue Precision Pen
Page 2 of 6
See Section 11 for additional toxicological information.
3. COMPOSITION / INFORMATION ON INGREDIENTS
Hazardous Component(s)
CAS Number
Percentage*
Ethyl 2-cyanoacrylate
7085-85-0
80 - 90
Treated fumed silica
67762-90-7
5 - 10
* Exact percentages may vary or are trade secret. Concentration range is provided to assist users in providing appropriate protections.
4. FIRST AID MEASURES
Inhalation:
Move to fresh air. If breathing is difficult, give oxygen. If not breathing, give
artificial respiration. If symptoms develop and persist, get medical attention.
Skin contact:
Do not pull bonded skin apart. Soak in warm soapy water. Gently peel apart
using a blunt instrument. If skin is burned due to the rapid generation of heat
by a large drop, seek medical attention. If lips are bonded, apply warm water
to the lips and encourage wetting and pressure from saliva in mouth. Peel or
roll lips apart. Do not pull lips apart with direct opposing force.
Eye contact:
Immediately flush with plenty of water for at least 15 minutes. Get medical
attention. If eyelids are bonded closed, release eyelashes with warm water by
covering with a wet pad. Do not force eye open. Cyanoacrylate will bond to
eye protein and will cause a lachrymatory effect which will help to debond the
adhesive. Keep eye covered until debonding is complete, usually within 1-3
days. Medical attention should be sought in case solid particles of
polymerized cyanoacrylate trapped behind the eyelid caused abrasive
damage.
Ingestion:
Ensure breathing passages are not obstructed. The product will polymerize
rapidly and bond to the mouth making it almost impossible to swallow. Saliva
will separate any solidified product in several hours. Prevent the patient from
swallowing any separated mass.
Symptoms:
See Section 11.
Notes to physician:
Surgery is not necessary to separate accidentally bonded tissues. Experience
has shown that bonded tissues are best treated by passive, non-surgical first
aid. If rapid curing has caused thermal burns they should be treated
symptomatically after adhesive is removed.
5. FIRE FIGHTING MEASURES
Extinguishing media:
Water spray (fog), foam, dry chemical or carbon dioxide.
Special firefighting procedures:
Wear a self-contained breathing apparatus with a full face piece operated in
pressure-demand or other positive pressure mode.
Unusual fire or explosion hazards:
Not available.