SDS

IDH number: 2223503
Product name: Loctite Re-New Specialty Silicone
Page 3 of 6
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Employers should complete an assessment of all workplaces to determine the need for, and selection of, proper exposure
controls and protective equipment for each task performed.
Hazardous Component(s)
ACGIH TLV
OSHA PEL
AIHA WEEL
OTHER
Calcium carbonate
10 mg/m3 TWA Total
dust.
5 mg/m3 PEL
Respirable fraction.
15 mg/m3 PEL Total
dust.
None
None
Dimethyl polysiloxane
None
None
None
None
Limestone
10 mg/m3 TWA Total
dust.
5 mg/m3 PEL
Respirable fraction.
15 mg/m3 PEL Total
dust.
None
None
Poly(oxy-1,2-ethanediyl), a-tridecyl-w-
hydroxy-~
None
None
None
None
Titanium dioxide
10 mg/m3 TWA
15 mg/m3 PEL Total
dust.
15 MPPCF TWA
Respirable fraction.
15 mg/m3 TWA Total
dust.
50 MPPCF TWA
Total dust.
5 mg/m3 TWA
Respirable fraction.
None
None
2-(4-Thiazolyl)benzimidazole
None
None
None
None
Engineering controls:
Local exhaust ventilation is recommended when general ventilation is not
sufficient to control airborne contamination below occupational exposure
limits.
Respiratory protection:
Use NIOSH approved respirator if there is potential to exceed exposure
limit(s).
Eye/face protection:
Safety goggles or safety glasses with side shields.
Skin protection:
Use impermeable gloves and protective clothing as necessary to prevent skin
contact.
9. PHYSICAL AND CHEMICAL PROPERTIES
Physical state:
Paste
Color:
White
Odor:
Characteristic
Odor threshold:
Not available.
pH:
Not available.
Vapor pressure:
< 1 mbar
Boiling point/range:
Not available.
Melting point/ range:
Not applicable
Vapor density:
Heavier than air.
Flash point:
Not applicable
Flammable/Explosive limits - lower:
Not available.
Flammable/Explosive limits - upper:
Not available.
Autoignition temperature:
Not applicable
Flammability:
Not applicable
Evaporation rate:
Not applicable
Solubility in water:
Insoluble
Partition coefficient (n-octanol/water):
Not available.
VOC content:
0.7 % (by weight, calculated using CARB method; g/L less water, less
exempts calculated using SCAQMD method)
Viscosity:
Not available.
Decomposition temperature:
Not available.