SDS

ManualsBrandsLoctite ManualsConstruction AdhesivePL Premium MAX 10 fl. oz. Construction Adhesive (12-Pack)

Safety Data Sheet

Revision Number: 002.0

Issue date: 09/29/2017

IDH number: 2292244

Product name: Loctite PL Premium Max Construction Adhesive

Page 1 of 7

1. PRODUCT AND COMPANY IDENTIFICATION

Product name:

Loctite PL Premium Max Construction

Adhesive

IDH number:

2292244

Product type:

Adhesive

Restriction of Use:

None identified

Region:

United States

Company address:

Contact information:

Henkel Corporation

One Henkel Way

Rocky Hill, Connecticut 06067

Telephone: +1 (800) 624-7767

MEDICAL EMERGENCY Phone: Poison Control Center 1-877-671-

4608 (toll free) or 1-303-592-1711 TRANSPORT EMERGENCY

Phone: CHEMTREC 1-800-424-9300 (toll free) or 1-703-527-3887

2. HAZARDS IDENTIFICATION

EMERGENCY OVERVIEW

WARNING:

MAY CAUSE AN ALLERGIC SKIN REACTION.

CAUSES SERIOUS EYE IRRITATION.

HAZARD CLASS

HAZARD CATEGORY

EYE IRRITATION

SKIN SENSITIZATION

PICTOGRAM(S)

Precautionary Statements

Prevention:

Avoid breathing vapors, mist, or spray. Wash affected area thoroughly after handling.

Contaminated work clothing should not be allowed out of the workplace. Wear protective

gloves, eye protection, and face protection.

Response:

IF ON SKIN: Wash with plenty of water. IF IN EYES: Rinse cautiously with water for several

minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If skin irritation or

rash occurs: Get medical attention. If eye irritation persists: Get medical attention. Wash

contaminated clothing before reuse.

Storage:

Not prescribed

Disposal:

Dispose of contents and/or container according to Federal, State/Provincial and local

governmental regulations.

6 % of the mixture consists of ingredient(s) of unknown acute toxicity.

Classification complies with OSHA Hazard Communication Standard (29 CFR 1910.1200) and is consistent with the provisions of the

United Nations Globally Harmonized System of Classification and Labeling of Chemicals (GHS).

See Section 11 for additional toxicological information.

3. COMPOSITION / INFORMATION ON INGREDIENTS

Hazardous Component(s)

CAS Number

Percentage*

Quartz (SiO2)

14808-60-7

50 - 60

Summary of content (7 pages)

PAGE 1
Safety Data Sheet Revision Number: 002.0 Issue date: 09/29/2017 1.
PAGE 2
Limestone Trimethoxyvinylsilane Gamma-glycidoxypropyl trimethoxysilane 3-(Trimethoxysilyl)propylamine N-(3(Trimethoxysilyl)propyl)ethylenediamine 2-Methylpropan-1-ol Ethylbenzene 1317-65-3 2768-02-7 2530-83-8 13822-56-5 10 - 20 1-5 0.1 - 1 0.1 - 1 1760-24-3 0.1 - 1 78-83-1 100-41-4 0.1 - 1 0.1 - 1 * Exact percentages may vary or are trade secret. Concentration range is provided to assist users in providing appropriate protections. Exposure to moisture during cure will release 1-2% methanol. 4.
PAGE 3
7. HANDLING AND STORAGE Handling: Do not handle contact lenses until all sealant has been removed from hands. Residual sealant may transfer to lenses and cause eye irritation. Avoid contact with eyes, skin and clothing. Keep out of the reach of children. Protect from moisture. Use only with adequate ventilation. Storage: For safe storage, store between -20 °C (-4°F) and 40 °C (104°F) Store in a cool, dry area. Avoid moisture.
PAGE 4
Vapor pressure: Boiling point/range: Melting point/ range: Specific gravity: Vapor density: Flash point: Flammable/Explosive limits - lower: Flammable/Explosive limits - upper: Autoignition temperature: Flammability: Evaporation rate: Solubility in water: Partition coefficient (n-octanol/water): VOC content: Viscosity: Decomposition temperature: Not applicable Not applicable Not applicable 1.65 Heavier than air. The product does not support combustion in any way. Not available. Not available.
PAGE 5
Potential Health Effects/Symptoms Inhalation: Skin contact: Eye contact: Ingestion: Hazardous Component(s) May be harmful if inhaled. Methanol is released during application and cure, which may affect the nervous system causing dizziness, headache or nausea. Abrasion of cured material such as by sanding or grinding could release respirable particles of silica quartz, a cancer hazard by inhalation. Normal use of this product causes no such release.
PAGE 6
13. DISPOSAL CONSIDERATIONS Information provided is for unused product only. Recommended method of disposal: Follow all local, state, federal and provincial regulations for disposal. Hazardous waste number: It is the responsibility of the user to determine if an item is hazardous as defined in the Resource Conservation and Recovery Act (RCRA) at the time of disposal. Product uses, transformations, mixtures, processes, etc.
PAGE 7
16. OTHER INFORMATION This safety data sheet contains changes from the previous version in sections: First issue. Prepared by: Product Safety and Regulatory Affairs Issue date: 09/29/2017 DISCLAIMER: The data contained herein are furnished for information only and are believed to be reliable. However, Henkel Corporation and its affiliates (“Henkel”) does not assume responsibility for any results obtained by persons over whose methods Henkel has no control.