SDS

IDH number: 2442595
Product name: Loctite Power Grab Ultimate Crystal Clear Adhesive
Page 2 of 5
Exposure to moisture during cure will release 0.1 - 0.9% methanol.
4. FIRST AID MEASURES
Inhalation:
Move to fresh air. If symptoms persist, seek medical advice.
Skin contact:
Wash with soap and water. If skin irritation persists, call a physician. Wipe off
paste with paper towel or cloth.
Eye contact:
Flush with copious amounts of water, preferably, lukewarm water for at least
15 minutes, holding eyelids open all the time. If symptoms develop and
persist, get medical attention.
Ingestion:
Do not induce vomiting. If a person feels unwell or symptoms of skin irritation
appear, consult a physician.
Symptoms:
See Section 11.
5. FIRE FIGHTING MEASURES
Extinguishing media:
carbon dioxide, foam, powder, water spray jet, fine water spray
Special firefighting procedures:
Wear protective equipment. Wear self-contained breathing apparatus.
Unusual fire or explosion hazards:
None identified.
Hazardous combustion products:
Upon decomposition, this product emits carbon monoxide, carbon dioxide
and/or low molecular weight hydrocarbons.
6. ACCIDENTAL RELEASE MEASURES
Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and unprotected
personnel.
Environmental precautions:
Do not allow product to enter sewer or waterways.
Clean-up methods:
Refer to Section 8 "Exposure Controls / Personal Protection" prior to clean up.
Store in a partly filled, closed container until disposal. Spilled material will
solidify. Scrape up as much material as possible. Maintain good ventilation for
large spills.
7. HANDLING AND STORAGE
Handling:
Do not wear contact lenses. Avoid contact with eyes, skin and clothing. Keep
out of the reach of children. Protect from moisture. Use only with adequate
ventilation.
Storage:
For safe storage, store between -20 °C (-4°F) and 40 °C (104°F)
Store in a cool, dry area. Avoid moisture.
For information on product shelf life, please review labels on container or check the Technical Data Sheet.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Employers should complete an assessment of all workplaces to determine the need for, and selection of, proper exposure
controls and protective equipment for each task performed.
Hazardous Component(s)
ACGIH TLV
OSHA PEL
AIHA WEEL
OTHER
Trimethoxyvinylsilane
None
None
None
None
3-Trimethoxysilylpropyl methacrylate
None
None
None
None