SDS

IDH number: 2450576
Product name: Loctite PL Premium Polyurethane Construction Adhesive
Page 3 of 6
Clean-up methods:
Ensure adequate ventilation. Scrape up spilled material and place in a closed
container for disposal. Wear suitable protective clothing, gloves and eye/face
protection.
7. HANDLING AND STORAGE
Handling:
Avoid contact with eyes, skin and clothing. Avoid extreme temperatures.
Exposure to vapors of heated MDI can be extremely dangerous. Wash
thoroughly after handling. Protect from moisture. Use only with adequate
ventilation.
Storage:
For safe storage, store between -20 °C (-4°F) and 50 °C (122°F)
Avoid moisture.
For information on product shelf life, please review labels on container or check the Technical Data Sheet.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Employers should complete an assessment of all workplaces to determine the need for, and selection of, proper exposure
controls and protective equipment for each task performed.
Hazardous Component(s)
ACGIH TLV
OSHA PEL
AIHA WEEL
OTHER
Methylenebis(phenylisocyanate)
0.005 ppm TWA
0.02 ppm (0.2
mg/m3) Ceiling
None
None
Methylene bisphenyl isocyanate
None
None
None
None
Talc
2 mg/m3 TWA
Respirable fraction.
0.1 mg/m3 TWA
Respirable.
2.4 MPPCF TWA
Respirable.
20 MPPCF TWA
None
50 ppm
Distillates (petroleum), hydrotreated
middle
5 mg/m3 TWA
Inhalable fraction.
5 mg/m3 PEL Mist.
None
None
Engineering controls:
Local exhaust ventilation is recommended when general ventilation is not
sufficient to control airborne contamination below occupational exposure
limits.
Respiratory protection:
Observe OSHA regulations for respirator use (29 CFR 1910.134). Use a
NIOSH approved air-purifying respirator if the potential to exceed established
exposure limits exists. Respirator with combination filter for vapor/particulate.
However, due to the poor warning properties of MDI, proper fit and timely
replacement of filter elements must be ensured.
Eye/face protection:
Safety glasses with side-shields. Full face protection should be used if the
potential for splashing or spraying of product exists.
Skin protection:
Suitable protective clothing
9. PHYSICAL AND CHEMICAL PROPERTIES
Physical state:
Solid
Color:
Tan
Odor:
Characteristic
Odor threshold:
Not available.
pH:
Neutral, Weakly, Alkaline
Vapor pressure:
Not available.
Boiling point/range:
172 - 341 °C (341.6 - 645.8 °F)no method
Melting point/ range:
Not available.
Specific gravity:
1.334 at 23 °C (73.4 °F)
Vapor density:
Heavier than air
Flash point:
182.9 °C (361.22 °F) ASTM D3278
Flammable/Explosive limits - lower:
Not available.
Flammable/Explosive limits - upper:
Not available.
Autoignition temperature:
Not available.