Installation Instructions

Tools Typically Required:
Tissue paper
Safety Precautions:
Wear gloves. Protect work area.
Preparation:
Surfaces to be bonded must be close fitting, clean, dry and free from oil, wax and paint. For best results, lightly roughen smooth
surfaces. Prefit parts to be joined.
Application:
To puncture the nozzle, screw the cap clockwise continuously into the base until the clicking sound stops. Unscrew the cap counter
clockwise to open the bottle. Squeeze the blue side grips to dispense the adhesive. Only one drop of adhesive per square inch of
surface is required. Press surfaces together immediately and hold for 15-30 seconds. Do not attempt to reposition the parts.
Immediately after use, clean tip with tissue and replace cap. For increased strength, leave the parts undisturbed for at least 10
minutes. Full cure in 24 hours. Note: Cure time is dependent upon temperature, humidity, porosity of surfaces and amount of
adhesive applied.
Clean-up:
After cleaning, wet any tissue used for wiping off glue with water and dispose of. When cleaning up larger quantities of uncured
adhesive, apply water and allow to cure and then scrape up. Note this may result in damage to the surfaces. Cured adhesive may
be cut away with caution using a sharp blade, removed with acetone or with boiling water. Note: Acetone is highly flammable and
may not be suitable for use on all materials, test surface first. Follow manufacturer’s instructions.