Operation Manual

n
Loewe AirSpeaker ID - 16 -
Deutsch English Français Italiano Español Nederlands PortuguêsMagyar
Polski
Čeština
n
- 16 -
Instructions for Use
Set-up/ Connection
Switching on/off
Set-up
• Place the unit on an even, firm, horizontal surface.
• Do not set up the unit near strong heat sources or in direct sunlight.
• If setting up in a shelf or a closed cupboard: Leave at least 2.5 cm
clearance around the unit, so that the air can circulate unhindered
and there is no heat backup.
• Incorrect voltages can damage the unit. This device may only be
connected to a power supply with the voltage and frequency indi-
cated on the type plate using the mains cable.
• Pull out the power cable during thunderstorms. A voltage surge
caused by lightning conducted through the mains could damage
the unit.
• If the unit is not to be used for an extended period, the plug should
also be disconnected from the mains.
• Position the mains cable in such a way that it can not be damaged.
The power cable may not be kinked or laid over sharp edges, stood
on or exposed to chemicals; the latter also applies to the unit as a
whole. A power cable with damaged insulation can cause electric
shocks and poses a fire risk.
• When you want to unplug from the mains, pull on the plug housing
rather than on the cable. The cables in the mains plug could oth-
erwise be damaged and could cause a short-circuit when plugged
in again.
Example congurations
Connection
Use the network cable provided to connect the network socket LAN
5
to a network connection (e.g. switch or DSL router) of your home
network with a connection to the Internet.
You can connect an external audio source to the socket AUX
8
. Use
an audio cable with 3.5 mm jack (available from your dealer).
Plug the network cable into the network socket AC-IN
4
and con-
nect it to a 220-240V 50/60 Hz socket.
Switching on/off
➠ First establish all cable connections, as described under „Connec-
tion“. In particular, the AirSpeaker ID must be connected to the
cable-based network before switching on, as it would otherwise
search for a connection in WLAN mode.
Press the on/off button
3
briey on the unit.
The unit switches on.
The LED indicator light in the ON/OFF button
3
lights up green.
To switch the device to Network Stand-by mode, press the ON/OFF
button
3
on the device for 3 seconds. The LED indicator light in
the ON/OFF button lights up orange.
➠ In Network Standby mode the AirSpeaker ID is still "visible" as an
AirPlay speaker, but consumes very little power (page 21). After
30 minutes without playback, the AirSpeaker ID automatically
switches to Network Standby mode.
To switch the device to Stand-by mode, press the ON/OFF button
3
on the device for 5 seconds. The LED indicator light in the ON/
OFF button lights up red.
➠ In Stand-by mode the AirSpeaker ID cannot be activated by other
devices, instead the ON/OFF button
3
has to be pressed again .
The power consumption
is very low here (page 21).
If you will be absent for some time, rst switch off the unit with the
ON/OFF button
3
and then pull out the mains plug. You can
thus save energy and protect the environment.
AC-INLANUSBRESET
AUX
3.5 mm Stereo Audio
Mains cable
Network cable
iPod USB cable
AirSpeaker ID
WiFi/LAN router