Operation Manual

n
Loewe AirSpeaker ID - 17 -
Deutsch English Français Italiano Español Nederlands PortuguêsMagyar
Polski
Čeština
n
- 17 -
Instructions for Use
Start-up
Basic settings
Network
Depending on whether the device is connected by wire (Ethernet,
Powerline)
or wirelessly (WiFi) to your home network, different settings have to
be made.
➠ Loewe recommends use of a wired network (Ethernet, Powerline)
to ensure a high stability and quality of the data link. Use a wireless
connection only if there is no option. Wireless connections can
basically get disturbed due to external influences (e.g. microwave
devices) and mostly provide a lower data transmission rate.
➠ The device must be registered in the same logical network as the
audio source (such as iPad)
Once you have carried out the relevant steps described in the chapters
"Set-up" and "Connection", switch on the unit.
Wired network
If your home network has a DHCP server (e.g. a DSL router), the setup
of the network parameters is done automatically. You do not need to
set up anything manually.
Wireless network - Conguration page
If you wish to set up a wireless network or if there is no DHCP server
in your home network, the AirSpeaker ID must be configured via a
direct connection between a PC and the AirSpeaker ID. Please use the
network cable provided to connect the AirSpeaker ID to the network
cnnection of the PC.
➠ It takes about 2 to 3 minutes from switching on the AirSpeaker ID
until a connection to the PC can be established.
➠ It takes about 2 to 3 minutes from switching on the AirSpeaker ID
until the device is „visible“ in the WLAN.
➠ A message might appear on the PC, stating that only a limited
network is available.
After the AirSpeaker ID has completely started, enter this address in the
Internet browser to call up the Configuration page: 169.254.111.222.
Example of a conguration page.
Then continue with the network settings as described
on page 18.
AirSpeaker
Network Setup Status SW Update
Cancel Apply
Select Option
AirSpeaker-FFF001
SSID
Use DHCP
Device Name
If the AirSpeaker ID is connected to a home network with DHCP server,
you can also access the Configuration page via a PC on which Apple
iTunes is installed:
Enter the address line in the PC Internet browser:
http://AirSpeaker ID-[xxxxxx].local/index.asp
where [xxxxxx] stands for the last six characters of the
MAC address. You can nd the MAC address on the
product label on the bottom of the unit
➠ If you change the „Device Name“ manually, the address (see above)
via which you can call up the Configuration page of the AirSpeak-
er ID will also change correspondingly. Please note the altered
„Device Name“. The new address is then : http://[newname].local/
index.asp