Operation Manual

n
Loewe AirSpeaker ID - 18 -
Deutsch English Français Italiano Español Nederlands PortuguêsMagyar
Polski
Čeština
n
- 18 -
Instructions for Use
Start-up
Basic settings
Network settings
The following network settings can be made:
Device Name The name that is used to identify the unit in the
network can be set individually.
SSID Selection of an available wireless network or
the option Configure Manually
Configure Manually Manual configuration of the WiFi network
Manual SSID Enter the network name of the desired WiFi
network
WPA Key Enter the network key of the selected WiFi
network
Use DHCP Select this option (box is ticked) to let the
WiFi router set the network parameters
automatically.
If this option is disabled you can manually set
the network parameters.
Select Encryption Type Select the encryption method.
No Encryption The connection is not encrypted (not
recommended)
WEP The connection is encrypted with the WEP
protocol (not recommended)
WPA The connection is encrypted with the WPA
protocol
WPA2 The connection is encrypted with the WPA2
protocol (recommended)
IP Address Fixed IP address assigned to the device
Subnet Mask Subnet mask of the home network (usually
255.255.255.0)
Gateway IP-address of the gateways
Primary DNS IP-address of the primary DNS server
Secondary DNS IP-address of the secondary DNS server
➠ Encryption using the WEP standard is no longer considered safe.
If possible, use the standards WPA or WPA2. Please make the
appropriate settings in your WiFi router.
You can find an overview of the network parameters, connections and
other technical details on the page Status.
AirSpeaker
Network Setup Status
Cancel Apply
Connection Status
Signal Strength
Wireless Channel
Firmware Version
Host Firmware Version
SSID
WEP Key
WPA Key
connected
good
5
3.8.86.1847
0.01.08
MyHomeNet
1b4u5y0xlsr22306
SW Update
Indicators
The indicators in the buttons on the unit show the different operating
states.
Function
Button
Button S Button - Button +
Standby red
Network Standby orange
ON green
Network initialising
/Network problem
green
ashing
yellow
AirPlay search ashing
violet
AirPlay mode green violet
AUX mode green green
USB mode green blue
Volume up/down white white
Mute ashing
white
ashing
white
Initialize Software
update
ashing
white or
orange
ashing
white
ashing
white
WiFi Software
update
orange
ashing
white
ashing
white
ashing
white
Contoller Software
update
green
ashing
white
ashing
white
ashing
white
Error during soft-
ware update
ashing
orange
Device error ashing
red
Software update
You can download a software update suitable for your unit from the
Internet, if required.
➠ AirSpeaker ID must be connected by cable to the network for a
software update.
➠ The power supply must never be disconnected from the device
during the updating process!
Open the Conguration Page as described on page 17.
Chose the tab SW update.
Use the Update function to start the update process.
The display in the S button lights up orange. The process
takes up to 30 minutes, depending on the speed of the
internet connection.
The device restarts after a successful update.
➠ You can download a current version of the instructions for use as
a PDF file from the Loewe web page: http://support.loewe.tv/de
– Library Instructions for Use This is especially recommended after
a software update.