Operation Manual

n
Loewe AirSpeaker ID - 20 -
Deutsch English Français Italiano Español Nederlands PortuguêsMagyar
Polski
Čeština
n
- 20 -
Instructions for Use
Troubleshooting
Troubleshooting
Problem Possible cause Remedy
Not working at all. Mains cable not plugged in. Plug the mains cable into a socket
230V 50 Hz.
No sound. Defective connections at the input cable. Connect the cable correctly (page 16). If the problem
continues, the cable might be defective.
The volume is set at minimum. Turn up the volume.
The sound is set to mute.
Press
or V+ on the remote control to reactivate the
audio output and then set the volume level.
The unit is not working properly. Unplug the mains plug from the mains socket and then
try plugging it in again after 90 seconds.
Press the Reset
7
button for > 10 seconds to restore
the default settings . Disconnect the device from the
power supply for 90 seconds. After this, please carry
out the basis settings again.
Sound interruptions during AirPlay
playback
Other devices in your environment might be
transmitting on the same radio channel.
Connect the AirSpeaker ID to a wired network or set a
free radio channel at your WiFI router.
The remote control is not working
properly.
The batteries in the remote control are dead. Replace the batteries with new ones.
The PC cannot establish a connection
to the AirSpeaker ID.
Check whether Apple iTunes is installed on the PC.
The iPod playback stops and another
title is played.
The iPod function “Shake to Shuffle” is acti-
vated.
Deactivate this function in your iPod.