Operation Manual

Art 40-55
User manual
26

Initial installation
Setting options for the satellite system (other communal
installation):
 Select satellite.
OK Confirm selection.
 Proceed to next step.
 Select and adapt settings.
LNC
frequency
Normally, you do not need to change the values for
high and low band, unless the LNC (LNB) of your
satellite system uses a different oscillator frequency
(important for the frequency display).
Supply
voltage
If your set is connected to a single-cable system
without external voltage supply, you can connect
the antenna supply (13V or 18V / max. 500mA).
 Proceed to next step.
Proceed to section Setting options for all types of
reception.
Optus D1160°E
Türksat 42°E
Hellas Sat2 39°E
Eutelsat 36A 36°E
Eutelsat 28A 28,5°E
ASTRA2 28,2°E
ASTRA3 23,5°E
Eutelsat 5 West A 5°W
Nilesat 7°W
Eutelsat 7 West A 7,2°W
Eutelsat 8 West A 8°W
Eutelsat 12 West A 12,5°W
Telestart12 12,5°W
Intelsat901 18°W
ASTRA1 19,2°E
Eutelsat 16A 16°E
Hot Bird 13°E
Eurobird 9A 9°E
Eurobird 7A 7°E
ASTRA4A 4,8°E
Thor/Intelsat10-02 0,8
Select satellites
Please specify here which satellite you receive.
Note: The newly selected parameter must be confirmed with the button.
Back with Proceed with
OK
Select
single satellite
LNB frequency, supply voltage
ASTRA1 19,2°E 9750 MHz 10000 MHz 10200 MHz 10600 MHz
Supply voltage off 13V 18V
Please specify the oscillator frequency for your LNB.
If your TV set is connected to a single cable system without an external power supply, you
can connect the antenna supply (13 or 18V/max. 350mA) with „13V“ or „18V“.
Back with Proceed with
LNB
frequencies,
Supply
voltage