Operation Manual

Loewe bild
User handbook
121

System settings
Multimedia / Network
Configuration of the built-in LAN adaptor
As network operation was selected On, wired only.
 Select type of IP configuration.
automatic Automatic configuration of the IP address via DHCP
server or via multiple protocols according to UPnP
specification (including DHCP).
After selecting IP configuration – automatic
proceed to the network status.
manual Enter your fixed IP addresses manually.
If manual has been selected under IP configuration:
 Enter IP, Subnet mask, Gateway and DNS server
addresses in succession with the numerical keys
on the remote control.
 Proceed to network status.
You see the current network status again.
BACK: End of wizard.
IP
configuration
Manual IP-
configuration
Network
status
Configuration of the built-in WLAN bridge adaptor
As network operation was selected On, wireless only.
The TV set now searches for wireless routers.
After the end of the search:
 Select a base channel to which the TV shall be
connected.
OK Confirm selection and proceed to the entry of the
Wi-Fi password.
If the desired access point is not found:
 Mark Search again,
OK repeat search for wireless routers.
Or:
 Mark Enter access point manually,
OK
enter manually the SSID of the desired access
point, e.g., when the SSID of the access point is
not transferred
.
The TV set automatically detects the type of encryption
used and informs you. You will find the supported
encryption types in chapter Technical data.
If your wireless network is not encrypted: Proceed to
IP configuration.
 Proceed to password entry.
Enter WLAN password.
In case of an unknown WLAN key, contact your
network administrator.
For WEP encryption
 Select the WEP index,
OK proceed to IP configuration.
 Select type of IP configuration.
For the further workflow of the network wizard
see left column under IP configuration.
Access point
selection
WPA
passphrase