Operation Manual

Loewe bild
User handbook
22

Initial installation
Select option.
OK Confirm selection.
With the selection, specify whether you want to
configure the available network adaptor now.
Configure now: Make settings for network
adaptor and proxy server (see chapter System
settings,section Multimedia / Network –
Network settings).
Do not configure or configure later: Skip
network adaptor configuration.
 Proceed to next step.
Select antenna cable.
OK Connect/disconnect antenna cable.
Select the antenna cables that are connected to
your TV.
Ahead of each selected antenna, the symbol
appears.
Cable analog: analogue channels via cable
Terrestrial (DVB-T/T2): digital channels via antenna
Cable (DVB-C): digital channels via cable
Satellite (DVB-S/cable 1): digital channels via satellite
Satellite (DVB-S/cable 2): digital channels via satellite
IPTV: Streaming via network (In-
ternet)
SAT>IP:
digital channel via local net-
work
With the connection sockets ANT SAT 1 / ANT
SAT2
(1
, when the TV set is switched on, it is auto-
matically detected whether an antenna cable is con-
nected. The symbol appears in the menu dialogue
behind the respective antenna cable
.
IPTV / SAT>IP can only be selected if a network-
connection has been configured in a previous step.
 Proceed to next step.
Network
configuration
Connect
antennas
cable(s)
The rest of the initial installation wizard routine
depends on the selected antennas (Cable analogue,
DVB-T/T2, DVB-C, DVB-S/S2, IPTV, SAT>IP (ASTRA))
in step Connect antennas cable(s).
The different antennas/types of reception are
described in the following sections of initial installation.
Setting options for reception via Cable analog:
If you have not selected Cable analog in step Connect antenna
cable(s) in the initial installation, proceed to the next section Setting
options for reception via SAT>IP
.
The selection of a Colour standard is only required
when the Location of TV set Other country was
selected. Otherwise, the country-specific default
settings will be preset when selecting the Location
of TV set. This step will be skipped then
 Select appropriate colour standard.
OK Confirm selection.
 Proceed to next step.
TV/col.
standard
(1
The ANT SAT 2 connection is only available for set types with dual-channel (see chapter Technical data - equipment features for your TV set).