Operation Manual
Loewe bild
User handbook
27
Initial installation
Setting options for the satellite system (single satellite):
Select satellite,
OK Confirm selection.
Proceed to next step.
Select Dual band (low/high) or Single band.
OK Confirm selection.
Here you specify if you use a Dual Band (Universal)
LNB or a Single LNB.
Proceed to next step.
Set LNB frequencies.
OK Adopt settings.
The setting of the LNB frequency is only called
when you have used the setting Single band
in step Dual / single band.
Normally, you do not need to change the values
for high and low band, unless the LNC (LNB) of
your satellite system uses a different oscillator
frequency (important for the frequency display).
Proceed to next step.
Proceed to section Setting options for DVB-S
reception (continued).
Select
single satellite
Dual/single
band
LNC
frequencies
Setting options for the satellite system (2 satellites on 22
kHz switchbox / 2 satellites on toneburst switch):
Mark Satellite 1 / Satellite 2,
select satellite.
OK Adopt settings.
Proceed to next step.
Proceed to section Setting options for DVB-S
reception (continued).
Satellite
selection