Operation Manual

Loewe bild
User handbook
28

Initial installation
Setting options for the satellite system
(max. 4 satellites on DiSEqC multiswitch):
 Select Automatic or Manual depending on
whether your DiSEqC system should be confi-
gured automatically or manually.
OK Accept settings.
 Proceed to next step.
For manual configuration, continue in the next column.
Search for available satellites occurs via automatic
configuration.
 Proceed to next step.
Or:
 Select Satellite selection to select the
satellites used from the list.
Proceed to section Setting options for all types of
reception.
Automatic
DiSEqC
multiswitch
configuration
Automatic
DiSEqC
multiswitch
configuration
 Select and adapt settings for the DiSEqC
multiswitch.
OK Adopt settings.
Repeat rate The refresh rate determines how often a DiSEqC
command is output. A refresh is only necessary with
cascaded systems.
Control
voltage
The control voltage controls the switching of the
polarisation level (horizontal/vertical) in non-DiSEqC
capable components (e.g., control of single LNBs via
DiSEqC multiswitch).
22kHz signal The 22 kHz signal controls the switching between
high and low band in the Band setting. The Position
setting controls the selection of the satellites in non-
DiSEqC capable components.
Toneburst The Toneburst controls the selection of the satellites
in non-DiSEqC but Toneburst capable components
with the Position and Option settings.
 Proceed to next step.
 Mark Satellite 1 ... Satellite 4,
 Select satellite.
OK Adopt settings.
 Proceed to next step.
 Set LNB frequencies.
Normally, you do not need to change the values.
OK Adopt settings.
 Proceed to next step.
Proceed to section Setting options for DVB-S
reception (continued).
Settings
DiSEqC
multiple
switch
Satellite
selection