Operation Manual
Loewe bild
User handbook
29
Initial installation
Setting options for the satellite system
(DiSEqC one cable communal system):
Select One channel or Two channels.
OK Confirm selection.
Here you specify if you use one or two transmission
channels in your one cable communal system.
In case of two channels - as far as they are
available in your system - different channels can
be simultaneously viewed on the main picture and
on PIP.
You get more information on your system from
your dealer.
Proceed to next step.
Select DiSEqC single cable communal
installation.
OK Confirm selection.
Proceed to next step.
Select satellites from list,
OK Confirm selection.
Proceed to next step.
Number of
system
channel used
DiSEqC
one cable
communal
installation
Satellite
selection
.
Set LNB frequencies.
Normally, you do not need to change the
values unless the LNC (LNB) of your satellite
system uses a different oscillator frequency
(important for the frequency display).
OK Adopt settings.
Proceed to next step.
Select and adjust settings for the DiSEqC
single cable communal installation.
OK Adopt settings.
The manual registration must be made for both ANT
SAT jacks when either two DVB-S antenna cables or
two system channels are used.
Transmission
channel
Select the desired transmission channel.
Transmission
frequency
Select the corresponding transmission frequency.
PIN protection
If your system is designed for it, it is possible to
protect your used transmission data from use by
other subscribers with a PIN.
DiSEqC
envelope
mode
Should your DiSEqC system occasionally show
problems during channel switching, you can switch
on the DiSEqC envelope mode to test whether the
switching problems then will no longer occur.
Define/
change PIN
Here you can determine and change the PIN for
PIN protection. Only possible, when yes has been
selected for PIN protection.
Proceed to next step.
Proceed to section Setting options for DVB-S
reception (continued).
LNB
frequencies
Manual
registration
(for socket
ANT SAT)