Operation Manual

Loewe bild
User handbook
64
Explanations of the setting options in the menu Timer data –
Additional options
Lock
recording
Only allow later playback of this recording after
entering the PIN number (Parental lock).
If a PIN still has not been entered under System
settings ט Control ט Parental lock, the
Parental lock will at first be activated. See
chapter System settings, section Control –
Parental lock for further information.
Delete
protection
Safeguard the recording from being deleted auto-
matically by using the delete manager.
Auto time
control
(1
Your TV set can use the automatic time control
(Accurate Recording) for recording a programme.
The automatic time control takes control of the
corresponding monitoring of the start and end time
for DVB channels. The recording is started at the
beginning of the broadcast and switched off at the
end, even if the start and/or end time have been
changed by the programme provider.
The automatic time control is not supported by
all channels.
If yes is selected and automatic time control is
not supported by the recorded channel then no
recording is made.
If the programme information (Event-ID) should
not be available any more for the recording of a
programmed broadcast. e.g., due to a programme
change or because the Event-ID has been changed
by the channel, the programme cannot be recor-
ded. The broadcasters alone are responsible for
the transfer of this data for using automatic time
control. The availability of the appropriate data
cannot be guaranteed by Loewe.
Recording
subtitles
Select whether broadcast subtitles are to be recor-
ded too.
In case of a direct recording the presetting is
taken from System settingsט Control טmore
... טDR+טRecording subtitles.
Favourite When selecting yes the recording will be added to
the Home favourites.
Record conflict
Despite the possibility of multi recording, it can happen when
programming a new recording that there will be an overlapping with
already stored timer recordings. In this case, the recording conflict
dialogue will open.
Here you can determine which of the recordings you want to be
executed, and you must eventually specify which of the programmes
shall be fully recorded and which are cut.
 Select recording,
OK change status.
The symbol before the recording shows you what
happens to the recording.
If the status for each recording is ok:
 Mark store recordings,
OK call.
The timer data of the recordings will be adjusted
accordingly.
Explanation of the symbols in the conflict manager:
TV programme is completely recorded.
Recording is cut off (at the beginning and/or end). Pay
attention to the start and end time of the recording.
The recording is deleted.
Delete/change programmed timer instruction
Use this function in the timer list if you want to delete recordings
already programmed, to end a running timer recording or to change
a timer instruction.
The Timer list is displayed.
Mark desired timer instruction,
The text of a currently active timer instruction is
red. If you delete this timer instruction, the record-
ing is stopped.
OK Change marked timer instruction.
The timer instruction will be displayed.
Or:
STOP: Delete marked timer instruction.
OKConfirm delete.
Timer instruction will be deleted.

Recordings
Timer
(1
only available if EPG data exists.