Operation Manual

Loewe bild
User handbook
90

System settings
Sound
Explanations of the sound settings (continued):
more ...
Loudspeaker/
Headphone
sound
Selection options for Mono/ Stereo or Sound 1 or
Sound 2 for bilingual programmes, separately for
the loudspeakers and the headphones.
The menu item appears only for analogue channels.
Auto volume
The volume may vary when receiving channels with
different standards, when switching from channel to
channel or during commercials.
You can reduce these differences in volume by
selecting auto volume on. For music and live broad-
casts you get a better sound spectrum with auto
volume off.
Maximum
volume
You can limit the volume adjustment of the loud-
speakers. This prevents selecting a volume which
is too loud.
Maximum
switch on
volume
Set the sound level to be heard after switching on the
TV set with the mains switch or after a power failure.
When switching on the TV set in standby mode, the
volume last used is retained unless it was above this
switch-on level. Otherwise it is limited by this.
Balance Set stereo balance so that the volume impression is
identical on the left and right.
Dynamic
SPDIF sync
Audio synchronization with external devices is
achieved by dynamically adjusting the SPDIF fre-
quency.
Some AVRs (Audio/video receivers) do not tolerate
any adjustment of the frequency of +/- 1000ppm
and show sound drop-outs or no sound at all.
Only in this case, please select here off.
Surround modus
(1
In the Surround mode menu point, two special virtualiser modes are
found that offer the possibility to simulate virtual surround sound via
the built-in TV loudspeakers.
Selecting the Surround mode
The choice is available for sound component - TV speakers. All other
audio components do not support this mode.
Adjustable in the System settings under Connections טSound
components.
The selection of surround modes is available when sound mode 
܃or܃ is used.
Adjustable in the System settings under Sound טSound mode
or in the current TV programme via the menu options (see chapter
TV, section Menu options).
HOME: Call Home view.
 Select System settings,
OK call System settings.
 Select Sound,
 go to next column.
Select Surround Mode,
OKcall.
Select the desired mode.
Explanation of the setting options:
Cinema
Surround
For the Cinema Surround mode an advanced
Virtualizer technology is used that is developed by
Loewe. This one improves speech intelligibility while
simultaneously widening the 3D sound.
Default setting ex factory.
Dolby Virtual Dolby Virtual simulates the hearing impression of
a 5.1 surround sound system via the built-in TV
speakers.
(1
Only for set types Loewe bild 9, Loewe bild 7, Loewe bild 5 oled and Loewe bild 4.