Operation Manual

Loewe bild
User handbook
95
Automatic scan TV+Radio
For automatic scan TV+Radio, a search wizard will be started that
searches for new channels which are not yet stored.
You have to repeat the initial installation and automatically search for
new channels if you want to delete all the existing channels and
automatically search for new ones.
HOME: Call Home view.
 Mark System settings,
OK call System settings.
 Mark Channels,
 go to next column.
Mark Automatic scan TV+Radio,
go to next column.
In the upper info text the current search settings will
now be displayed:
If you want to change these search settings:
 Select Change search settings,
OKwizard guides you through the search settings
(see column on the right).
If you agree with these settings:
 Select Start search/update,
OKstart scan.
BACK: Cancel current search/update.
Explanations of some search settings:
Signal source Select here cable analogue, terrestrial (DVB-T /
T2), cable (DVB-C), satellite (DVB-S / S2) or IPTV
depending on the signal source you wish to use to
search for new channels.
Use the Antenna wizard to call the configuration of
the DVB-T and DVB-S antennas.
Calling up the DVB antenna configuration causes
the Change search settings dialogue to be quit.
You must call up the dialogue again after finishing
the configuration.
Cable
(analogue)
TV/colour
standard
With the selection of TV set location the conventional
TV standard/colour standard is the default.
It should only be changed if channels with other
standards are to be searched.
Explanations of some search settings (continued):
DVB-T/C/S
IPTV
Network
selection
If several networks are available, you can decide
which network you want to receive your channels
from.
DVB-T/C/S
IPTV
Settings
With the selection of set location the conventional
settings will be preset. Only change these defaults
if you are familiar with other parameters.
Scrambled channels: (DVB-T/C/S)
You can state whether scrambled channels are to be
searched for in the search/update. If you select yes,
coded channels will also be searched for. However,
these channels can only be received in connection
with a CA module and the appropriate Smart Card.
Ask your dealer which Smart Card you need to
receive certain channels.
Search method: (DVB-T)
If you want to run the channel search independently
of the channel grid, select Frequency search for the
search method.
Search method: (DVB-C)
If you select Frequency search here, a search is
performed for all receivable channels. With Network
search, only the channels which the networks sup-
ply are searched - either for all receivable networks
or only for the particular network specified under
Network ID.
Network ID: (DVB-C)
If you select none here, DVB signals of all current
broadcasting networks are scanned automatically
(recommended for most cable networks).
If, on the other hand, you specify a certain network ID
(necessary in the cable networks of some countries),
only DVB signals of this broadcasting network are
searched for automatically. Your cable provider has
the information you need.
Search method: (DVB-S)
If you select Frequency search here, a search is
performed for all receivable channels. With Network
search, from all receivable networks all the channels
are searched which are supplied by these networks.
Accept Logical Channel Number: (DVB-T/C/S)
In various countries, digital channels (DVB-T/C/S)
are transmitted with a preset channel number per
channel, known as Logical Channel Numbers (LCN).
If you select yes here, these default channel slots
will be used and the channels of the preferred signal
source will be sorted as per LCN. The channels in
the channel list can no longer be shifted.

System settings
Channels