Operation Manual

Individual 40-55
User guide
24

Initial installation
Setting options for DVB-C reception:
If you have not selected DVB-C antenna in the list of available antennas:
Proceed to Setting options for DVB-S reception.
If a CA module is plugged in during Initial installation and if the item
Stations in the special station list was selected in Extent of
station search, the station list of the CA module will be adopted.
Further settings described on this page will then be skipped. The
procedure of the initial installation will then be continued with the
step Setting options for DVB-S reception.
If several networks are available via DVB-C, you can
decide which network you want to receive your chan-
nels from. The normal DVB-C settings are derived from
the selection of the location or network and do not
need to be changed. Exactly which of the following
settings are present is dependent on which network is
selected.
 Select network.
OK Confirm selection.
 Proceed to next step.
 Select and adapt settings for DVB-C recep-
tion.
Network
selection
Please state from which network you wish to receive your station.
Note: The newly selected parameter must be confirmed with the button.
Unitymedia
Standard
Network selection (DVB-C)
Back with Proceed with
OK
Please specify whether you want to search for scrambled stations too.
Note: Scrambled stations can only be received with an integrated CA module and additional
card.
DVB-C settings
Scrambled stations
Search method
Start frequency
Network ID
Accept Logical Channel Number
no yes
Network search Frequency search
044.00 MHz
none 00000
no yes
Back with Proceed with
Settings
Scrambled
stations
You can state whether coded stations are to be
searched for in the search/update.
Select yes to
save all found scrambled stations. However, these
stations can only be received in connection with a CA
module and the appropriate Smart Card.
Handling
of the CA module is described in chapter Extras,
section CA module.
Search
method
If you select Frequency search here, a search is
performed for all receivable stations. With Network
search, only the stations which the networks supply
are searched - either for all receivable networks
or only for the particular network specified under
Network ID.
Start
frequency
The DVB stations are only searched for in the fre-
quency range above the start frequency.
Network ID If you select none here, DVB signals of all current
transmitter networks are searched automatically
(recommended for most cable networks).
If, on the other hand, you specify a certain network ID
(necessary in the cable networks of some countries),
only DVB signals of this broadcasting network are
searched for automatically.
Your cable provider has the information you need.
Accept
Logical
Channel
Number
In various countries, digital stations (DVB-C) are
transmitted with a preset channel number per
station, known as Logical Channel Numbers (LCN).
If you select yes here, these default channel slots
will be used and the channels of the preferred signal
source will be sorted as per LCN. The stations in the
station list can no longer be shifted.
 Proceed to next step.