Operation Manual
Start-up
Subwoofer
If you have connected up a subwoofer to the Multiroom Receiver (page 33), then
the Limit frequency should be set so that the bass sections are no longer played
back by the stereo speakers but by the subwoofer.
Press the ROOM button.
Select Room. Confirm with OK.
Select Receiver settings.
Confirm with OK.
Select Subwoofer.
Confirm with OK.
+]
+]
+]
+]
+]
6XEZRRIHU
5RRP
/LPLWIUHTXHQF\
Rဴ
Select option.
Select the option off, if no subwoofer is connected.
Select 20-200Hz, depending on the limit frequency of the
stereo speakers connected (refer to their technical data).
Confirm with OK.
➠ Make sure you have switched off the Multiroom Receiver
before connection.
Audio Output
You can set a fixed or a variable volume for the audio signal at the port AUDIO OUT.
Select Receiver settings.
Confirm OK.
Select AUDIO OUT.
Select an option.
fix loudness level fixed
variable loudness level variable, adjustable with V+/-
➠ This option is not available if a subwoofer limit frequency has been set.
Energy saving mode
By activating the energy-saving operating mode, you can save the most energy
(see page 47). It will however take somewhat longer to switch on the device. You
can set two time periods in which the unit gets automatically switched on at a
given time (= energy-saving mode off) and then off again.
Press the ROOM button.
Select Room.
Confirm with OK.
Select Receiver settings.
Confirm with OK.
Select Energy saving mode.
Confirm with OK.
0RGH
6WDUWWLPH
(QGWLPH
6WDUWWLPH
(QGWLPH
RQ7LPHU
(QHUJ\VDYLQJPRGH
5RRP
Select option.
on energy-saving operating mode active
off energy-saving operating mode off
on+Timer Automatic switching on/off of the energy saving mode.
There are two Start/End times possible.
During the times that have been set, the appliance is quickly
ready for operation (= energy saving mode off), whereas
during the other period, it is in energy saving mode.
Input the time in four digits in 24h format.
Close the menu.
- 38
English