Operation Manual

Setting up
Setup
• The unit is suitable for various set-up solutions. Please pay attention to the
respective mounting instructions.
• Only place the unit with a table or stand on a level, firm, horizontal surface.
When being set up, the unit should, in particular, not protrude into or over
furniture.
Positioning in the room
The Sound Projector gives out surround sound by reflecting projected sound waves
off the walls in your room. The surround sound effect generated by the unit may
not be sufficient if the unit is installed in a room with the following characteristics:
• Rooms in which the walls are not suitable for reflecting sound waves.
• Rooms with sound damping surfaces.
• Rooms whose dimensions are greater than the following range:
width (3 - 7 m) × height (2 - 3.5 m) × depth (3 - 7 m).
• Rooms in which the listening position is less than 1.8 m away from the
loudspeaker position.
• Rooms in which, for example, furniture could block the path of the sound
beams.
• Rooms in which the listening position is close to the wall.
• Rooms in which the listening position is not in front of the unit.
Install the Sound Projector in a position where the path of the sound beams is
not impeded by obstacles, such as furniture. Otherwise the desired surround sound
effects may not be obtained.
You can install the unit parallel to the wall or in a corner.
Position parallel to the wall
Install the Sound Projector exactly in the middle of the wall, measured precisely
from the left and the right corner.
Position in a corner
Install the Sound Projector in a corner at an angle of 40º to 50º to the adjoin-
ing walls.
Example: 5.1 Mode.
11 -