Operation Manual

Connecting
Sound Projector in the Loewe TV Composite
System
Connect, using the accompanying RS-232C system cable, the RJ12/RS-232C
socket of the Sound Projector to the RJ12/RS-232C socket on your Loewe TV-
set (from Chassis SL 1xx onwards). You need to connect this in order to control
the Sound Projector.
Connect the socket HDMI OUT of the Sound Projector using the accompanying
HDMI cable to a free HDMI socket of your TV-set. Connecting this is optional and
is only recommended if you wish to connect further HDMI devices to your TV set
using the Sound Projector.
Connect the DIGITAL IN TV socket of the Sound Projector using the accompanying
cinch cable (Digital-Audio cable: plug is orange in colour) to the AUDIO DIGITAL
OUT socket of your TV set. Via this connection, the digital sound signal of the TV
set is transmitted to the Sound Projector.
Connect the AUDIO LINK socket of the Sound Projector with an Audio Link cable
to the AUDIO LINK socket of a Loewe Subwoofer that is available as an accessory.
Use the accompanying antenna cable to connect the socket ANTENNA IN FM
to an antenna socket.
Using the mains cable, connect the socket AC IN of the Sound Projector to a
220-240V 50/60 Hz socket with protective ground.
HDMI
OUT
HDMI
IN 1
HDMI
IN 2
HDMI
IN 3
HDMI
IN 4
AudioLink
Line In
Speaker
Out
Power Mode
Left
Center
Right
Left Right Left Right
230V~50/60Hz
Left
Phase
Equalizer
Crossover
Frequency
Bass
Intensity
180°
-3dB
+6dB
50Hz
250Hz
min
max
0°
Subw Right
Rear
Front
OFF ON Auto Manu.
Front Rear
13 -
Loewe at TV set (from SL 1xx onwards)
Loewe Individual Sound Projector
Loewe Subwoofer Individual Sound Highline
Digital audio cable System cable RJ-12/RS-232C
FM Antenna
Audio link cable
HDMI cable