Operation Manual

Start-up
Using the remote control for the first time
To insert or change the batteries, press where the arrow is embossed on the cas-
ing. While doing so, simply slide the battery compartment lid down and remove it.
Insert alkaline manganese batteries LR 03 (AAA) and ensure the correct position
of + and –. Slide the cover on again from the bottom.
Setting up the Assist Remote Control
Other Devices
You can operate various Loewe devices using the Assist Remote Control. The device
buttons REC - SP - AUDIO can be set up for this.
Press the required device buttons and the Stop button
simultaneously for 5 sec. until the corresponding LED display
flashes twice.
Then select the two-digit device code from the table:
Unit Code Factory setting
Loewe ViewVision 8106 H 10
Loewe ViewVision, Centros 21x2 12
Loewe ViewVision DR+ DVB-T 13 REC
Loewe Auro 2216 PS/8116 DT 14
Loewe BlutechVision 15
Loewe Soundprojector 1 17
Loewe TV Radio digital 19 AUDIO
Loewe Mediacenter 20
Loewe BlutechVision Interactive 21
HDMI CEC Mode 
22
Loewe AudioVision 24
Loewe Sound Projector ID 25 SP
Restore defaults 99
The corresponding LED Display flashes twice.
Sound functions
It is possible to set the devices with which the buttons with the sound functions
(V+/-, Mute and sound mode) should work.
Depending upon which device configuration you use (page 13- page 15), set the
device keys and sound functions of the Assist remote control. If you use the inte-
grated network configuration as described on page 13, the Loewe TV set will process
the sound and the sound functions of the Assist remote control do not have to be
changed. With a configuration as described on page 14 and page 15, it is necessary
to change the sound functions on the Assist remote control as described below.
Press the device button TV and, at the same time, the button
with the single digit function code from the list, for 5 sec. until
the LED Display flashes twice.
Function Code Figure
Loewe AudioVision 3
Loewe Mediacenter 4
Loewe TV 
5 Page 13 / Page 14
Loewe Sound Projector 6 Page 15
 Factory setting
 From chassis L27xx with software ≥ 9.16 and chassis SL 1xx with software ≥ V2.6
Operating Loewe Equipment
Using the remote control for a Loewe TV set
Press TV button; the LED Display above it lights up for approx.
5 seconds
Using the remote control for a Loewe recorder
Press the REC button; the LED Display above it lights up for ap-
prox. 5 seconds
Using the remote control for Sound Projector
Press the SP button; the LED Display above it lights up for approx.
5 seconds
Using the remote control for Mediacenter
Press the AUDIO button; the LED Display above it lights up for
approx. 5 seconds
Every time a button is pressed, the LED display lights up for the selected operating
mode for checking purposes (TV – REC – SP – AUDIO).
Please refer to the respective operating conditions on how to operate the indi-
vidual devices.
- 16