Operation Manual

Start-up
After auto set-up has been completed, a message will appear
on the screen.
Example 1 - Successful auto set-up:
[END] : Cancel
[OK] : Save set-up.
SHOW RESULT
BEAM MODE : ST+3Beam/Plus2
SUBWOOFER : NOT APPLICABLE
Example 2 - Failed auto set-up:
[END] : Cancel
ERROR E - 5
Please check MIC position.
MIC should be set above
1.8m/6.0ft and re-try.
➠ If an error message is displayed, correct the conditions and then please repeat the
auto set-up . Please also read the “Error messages for auto set-up “ on page 32.
OK Apply results of auto set-up.
Remove the microphone now from the Sound Projector.
The Sound Projector is now ready.
You will find information on operating the Sound Projector
from page 23 onwards.
Saving sound set-up
You can save up to three sound set-ups. This allows you, for example, to take
different listening positions, the actual room or TV positions into consideration
when using a Loewe TV with swivel castor control. You can than call up these
sound set-ups at any time.
Press the button for a long time. The menu Memory is
displayed.

[] / [] : Up / Down
[OK] : Enter
MEMORY
1) LOAD
2) SAVE
56 Select the option Save.
Confirm OK.

[] / [] : Up / Down
[OK] : Enter
2) MEMORY SAVE
a) MEMORY 1
b) MEMORY 2
c) MEMORY 3
56 Select the option MEMORY1-3.
Confirm OK.
➠ All settings you adjusted in the Sound Projector menus are permanently
stored by saving.
- 22