Operation Manual

Everyday Use
Playback
Switch sound on/off
Sound off;
Sound on: Press the button again or set the V+/- volume
(loudness).
Adjusting volume
V+/V– volume up / down
or on the unit, press Volume - / +.
Other sound settings for TV sets with RS-232C System
Interface
➠ As long as the volume bar or the selection of loudspeakers can still be seen
in listening mode.
5Call up additional sound settings.
34Select sound settings.
6 Change to the menu line below.
34Make changes.
➠ You can also make sound settings in Loewe TV sets from Chassis SL 1xx
onwards in TV-MENU – Sound.
Loading listening position
You can call up the listening position that you saved previously (page 19, page 21).
TV sets with RS-232C system interface
➠ No further menu is shown.
34 Select the listening position.
OK
SOUND COMPONENTS WIZARD
Select one of the three memory positions for the new sound adjustment which
will be set subsequently.
SOUND PROJECTOR
Select memory position
Position 1 (MEM1)
Position 2 (MEM2) Position 3 (MEM3)
Proceed
OK
34 Select one of the three memory positions Position 1-3
(MEM1-3).
Confirm OK.
TV sets with an RS-232C system interface and swivel
castor control
➠ No further menu is shown.
34 Select the listening position.
OK
SOUND COMPONENTS WIZARD
Turn your TV set by using the cursor keys left/right to the desired listening
which is optimal for your listening position and confirm with the key.
SOUND PROJECTOR
Rotate TV
-30
Proceed
OK
OK
34 Select one of the three memory positions Position 1-3
(MEM1-3). These are marked on the bar.
Selecting signal source
You can play back the sound from the devices connected to the Sound Projector.
Set the remote control for Sound Projector operation.
Press AUX (PIP) on the remote control several times
or press SOURCE several times on the unit to select the
required signal source.
The name of the selected input signal source and the type of corresponding input
mode are shown on the Sound Projector display.
23 -