Operation Manual

Other settings
If required, you can configure additional parameters in the Settings menu of the
Sound Projector. These settings are only intended for trained technical personnel.
➠ Unless you have sufficient expertise, do not make any changes to the settings
in this area, as this may maladjust the unit to an extent that it no longer
works properly afterwards.
Loudspeakers
You can determine the number of sound beam output channels and the audio
output mode.
Select AV station preset of the TV-set to which the Sound
Projector is connected.
Set the remote control for Sound Projector operation. The
Sound Projector switches on automatically.
Press the MENU briefly. The menu Settings appears.
56 Select the option Loudspeakers.
Confirm OK 2x.

·
·
·
·
·
·
·
[] / [] : Up / Down
[OK] : Enter
SET MENU
MEMORY
AUTO SETUP
MANUAL SETUP
SOUNDSET MENU
SOUNDOUT MENU
INPUT MENU
DISPLAY MENU
Number of channels Set 5.1 ch or 7.1 ch mode
Beam mode Depending on your setting for Number of channels,
you can choose to set
5.1 ch: 3 Beam or Stereo + 3 Beam or 5 Beam, or
7.1 ch: 3 Beam, Stereo + 3 Beam plus 2
or 5 Beam plus 2 (also see Listening mode on
page 24)
Connections
You can make basic settings for the inputs/outputs.
Assign connections
You can assign analogue and digital wired (coaxial) and optical inputs respectively
to the video inputs (page 23).
Renaming the connections
You can rename the connections, e.g. so that it can be seen from the display of
the Sound Projector, which connected units (e.g. Blu-ray-Player) are set upon
selecting the signal source (page 23).
Setting HDMI
Here, you can make additional settings for the HDMI-interfaces.
Support Audio Select Loewe SP to play back HDMI audio signals
on that unit. Select Other, to play back HDMI audio
signals on one of the components connected to the
HDMI OUT socket
Audio select Here, you can set whether the audio channel of the
HDMI-IN-sockets 1-4 should be active
HDMI control Set this option to On if your TV-set and the connected
sets (e.g. Blu-ray-Player) support the HDMI CEC
function. There is then an automatic switch-over to
the respective HDMI source.
Display
You can make settings for the device display of the Sound Projector.
F.DISPLAYSETUP You can set the brightness of the display here
OSD setup You can adjust the colour and position of the menu
Settings here.
Language setup You can set the language of the operating interface
here (see page 21)
Unit setup You can set the unit of measure to feet or metres
- 30