Operation Manual

SoundPort / SoundPort Compact / SoundPort Mini
Operating instructions
English
38

Switching ON/OFF
Charging the audio source
Switching on
When switched off, the LED display is
8
dark.
Switch the power switch
11
to position ON.
The SoundPort is in the Standby mode.
The middle two segments of the LED display
8
light dimmed.
Press the ON/OFF key
1
on the unit.
The LED display
8
lights up green on the very first start (AUDIO IN source).
When switching on later, the last selected source remains active.
For the colours of the LED display for each source, see page 39.
After 10 minutes without music playback, receiving or sending a call, pressing a key
on the SoundPort or on the Assist remote control (see page 52), connecting or
disconnecting a device and running a sync process, the SoundPort will automatically
switch to Smart Standby mode.
For further information on the energy modes see page 51.
Switching off
Press the ON/OFF key
1
on the unit.
The SoundPort switches to the Standby mode.
The middle two segments of the LED display
8
light dimmed.
After 4 hours in Smart Standby mode, the SoundPort automatically switches to the
Standby mode.
For further information on the energy modes see page 51.
Charging the audio source
You may charge the battery of your audio source, e.g., a mobile phone, iPad, etc. via your SoundPort.
The power switch of the SoundPort must be switched on.
Only one device should be charged at the same time.
Charging of iDevices at the Lightning Connector:
Plug your iDevice with Lightning Connector on the Lightning Connector built-in in the
SoundPort
6
(see pages 42 and 43).
Charging of USB audio sources:
Connect the type A plug of the USB cable into the USB socket
16
of the SoundPort. To do
this, use a USB cable with type A plug suitable for your audio source (commercially available).
The connected device (Lightning / USB) is charged in both the operating and the Smart
Standby mode of the SoundPort. The audio source will not be charged in Standby mode.