Operation Manual

5
REMOVING THE FINGER
The finger (998) device was designed to work with the rope-chain. If you use chain only we suggest to remove it to avoid wear and tear and noise. You can fit the plug (945) where the
finger was previoulsy installed. The disinstallation needs 4 steps :
1. Low profile model : Unscrew the (993). Standard model : unscrew the (912) and remove the (991).Remove the (990 , 988) and the (989).
2. Unscrew the two (984) and (907) and extract the (983).
3. Turn the (983) and unscrew the (293) and the (998 , 906). Insert the (945) into (998) and screw (293) again. Remove (909) from the (980).
4. Remount the (983) and all the other parts.
LOFRANS LIMITED INTERNATIONAL WARRANTY
Lofrans warrants this product for a period of 2 years subjected to the conditions listed below :
1. The product must be registered
. The registration must be done within 30 days from the date of purchase by one of these options : online going to the web site
www.lofrans.com
under the page “Product Registration”and following the instructions or by faxing to +039 2004299 the completed registration card attached to the
instruction manual.
2. This warranty starts from the date of purchase of the product from the original purchaser. If the product is first equipment of a new boat the warranty starts from the date of
purchase of the boat.
3. This warranty covers original defects in material and workmanship.
4. This warranty is limited to the repairment and/or the replacement of the original defective part.
5. The claim of warranty must be promptly notified in writing and sent by fax or e-mail to Lofrans or Lofrans authorised distributor providing the serial number of the product and
the registration warranty number. Lofrans reserves the right to require the proof of purchase of the product to accept the claim of warranty.
6. The defective part/product must be returned to Lofrans or Lofrans authorized distributor. List of authorised distributors is available on the web site www.lofrans.com
.
7. This warranty does not cover failures due to : use of the product in applications for which they are not intended , corrosion , normal wear and tear , discoloration ,
unauthorised alteration of the product , improper installation , incorrect use or maintenance of the product , conditions that exceed the product’s performance specifications
8. This warranty does not cover any loss or damages to the original purchaser due to a proven non conformity of the product with the exception of the cases ruled by the Italian
law.
9. Lofrans reserves the right to disclaim the warranty in case the product be controlled by improper electric devices and/or in case of non installation of a proper circuit breaker
on the electric power line.
The consumer statutory rights are not affected by this warranty according to the national legislation, disciplining the sale of goods.
This warranty is ruled by the Italian law
For every controversy the Court of Milan is competent exclusively.
APPENDIX
GIPSY CODE TIPE OF CHAIN DIAMETER PITCH ROPE DIAMETER
08102 8 ISO 8 mm 24 mm 16 mm – 5/8”
8 German Din 766 8 mm 24 mm 16 mm – 5/8”
5/16”American Acco BBB 5/16” 1,00” 16 mm – 5/8”
5/16”American G-4 ISO 5/16” 1,03” 16 mm – 5/8”
10 ISO 10 mm 30 mm 18 mm – ¾”
10103 3/8”American G-4 ISO 3/8” 1,23” 18 mm – ¾”
10104 10 German Din 766 10 mm 28 mm 18 mm – ¾”
12101 12 ISO 12 mm 36 mm 20 mm – ¾”
7/16”American G-4 ISO 20 mm – ¾”
www.busse-yachtshop.de | [e-mail]