Trimmer User Manual

ManualsBrandsLogan Graphic Products ManualsTrimmerT300

Total Trimmer

www.logangraphic.com

General PurPose Trimmer

For best results use only

authentic Logan blades

Purchase Date

Model T300

Model T360

Instruction Manual

Introduction

The Logan Trimmer offers many unique features and durability that make it the best value trimmer/cutter available.

Capable of handling your most demanding trimming needs, the Total Trimmer is the versatile work-horse trimmer you

have been looking for. Ideal for trimming difﬁcult materials like PVC foamboard and vinyl, it also easily cuts common

materials such as ﬁlms, paper and almost any ﬂexible or rigid materials. Easy to use, ergonomic design, safety

features and inexpensive cost makes the Total Trimmer a cutter with great features at a great price.

For advice, assistance or replacement parts please contact us at www.logangraphic.com

Summary of content (4 pages)

PAGE 1
Instruction Manual Model T300 Model T360 General Purpose Trimmer Total Trimmer Introduction The Logan Trimmer offers many unique features and durability that make it the best value trimmer/cutter available. Capable of handling your most demanding trimming needs, the Total Trimmer is the versatile work-horse trimmer you have been looking for.
PAGE 2
Instruction Manual Identification Board A. Squaring Arm B. Squaring Arm Stop C. Lifter D. Cutting Head E. Cutting Bar F. Handle Bar Model T300 & T360 Total Trimmer C Head G. Blade Knob H. Depth Adjustment Knob I. Plunger Pin J. Blade Holder Safety • Remove blades when servicing machine. • Do no place your fingers near blade when using machine. • Be sure lifter bar is down when cutting. • Do not force cutting head if stuck. B A J D F E G I Fig. 1 H Fig. 2 Assembly Attaching Squaring Arm & Stop 1.
PAGE 3
Instruction Manual Total Trimmer Model T300 &T360 Operation 1. Raise cutting bar using lifter arm or raise to full open position. (Fig. 6) Fig. 6 Fig. 7 2. Slide material onto board and against squaring arm. (Fig. 7) 3. Adjust Stop to desired dimension. (Fig. 8) 4. Lower Cutting Bar 5. Slide Cutting Head beyond end of material. 6. Pivot blade down fully until it locks. (Fig. 9) 7. Place hand on to cutting handle & pull cutting head down through material until head reaches support bar. (Fig 10) Fig.
PAGE 4
Instruction Manual Total Trimmer Model T300 &T360 Maintenance and Adjustment Cutting Head Bearings If cutting head is loose or wobbling, tighten three adjustment screws to eliminate the play and improve cut accuracy. (Fig. 12) Fig. 12 Adjustment Screws Resquare Squaring Arm 1. Place a carpenter’s square against cutting bar first. Slide against squaring arm and look for gaps between square and squaring arm. (Fig. 13) 2. Notice which way squaring arm would have to move to eliminate gap. 3.