Datasheet

Listening to the Radio
1. With the unit switched ON, press the SOURCE button on the unit or remote control to select the FM or AM
Radio mode.
2. To manually scan through the radio frequencies, repeatedly press the TUNING + or - buttons on the unit or
the ‘RW/TUNER-’, ‘FF/TUNER+’ buttons on the remote control.
3. To automatically scan through the radio frequencies. Press and hold the TUNING + or - buttons on the unit
or the ‘RW/TUNER-’, ‘FF/TUNER+’ buttons on the remote control. The scan will automatically stop when
a strong signal is found.
4. The display will automatically show the set time if the unit is left idle for 5 seconds, to briefly view the
current radio station press the PRESET button on the unit or remote control.
Presetting Stations in the Radio Memory
The MIP199 can store up to 10FM and 10AM radio stations.
1. Select the frequency you want to store into the memory.
2. Press the ‘MEMORY’ button on the unit or remote control, ‘P01’ will begin to flash on the front display.
Press the TUNING + or - buttons on the unit or the ‘RW/TUNER-’, ‘FF/TUNER+’ buttons on the remote
control to select between presets ‘P01’  ‘P10’.
3. Press the ‘MEMORY’ button to store the frequency. The display will stop flashing to indicate the frequency
is now stored into the memory.
4. Press the SOURCE button to switch to the AM and FM bands and repeat the above procedure to store up
to 10AM or 10 FM frequencies into the memory.
Recalling Preset Stations
1. Press the ‘SOURCE’ button to select AM Radio or FM Radio.
2. Press and hold the PRESET button for 2 seconds
3. Press the TUNING + or - buttons on the unit or the ‘RW/TUNER-’, ‘FF/TUNER+’ buttons on the remote
control to select between the preset frequencies
Antenna
The unit has a built in FM Antenna, use the aerial wire at the back of the unit for the clearest possible FM
signal.