Operating instructions

INPUT SELECTION
Using the front display
1. Press the INPUT button on the front panel.
Press the INPUT button to select which input mode you require according to your setup. The input sequence is as following:
Optical 1  Optical 2  Coaxial 1  Coaxial 2  Aux  87.50 (FM Radio)
a. If ‘OP1’ is shown on the LCD this indicates that the Optical 1 input is selected.
b. Press the VOLUME + - buttons on the front panel or remote control to adjust the volume level between 00  63.
c. To select the next input source, press the INPUT button until it is shown on the LCD.
POWER
1. Connect the Power Cable Plug into your AC Mains Supply and switch
it to the ON position.
2. Press the POWER switch on the left side panel to switch the unit ON
3. “-” will appear on the front LCD to indicate it is in Standby mode.
4. Press the STANDBY button on the front panel or remote control to
enter Normal mode.
5. To switch the unit OFF press the POWER switch on the left side
panel.
Using the remote control
a. Press the OPTICAL 1 / 2 buttons, to select the Optical 1 or 2 inputs, ‘OP1’ or ‘OP2’ will appear on the LCD.
b. Press the COAXIAL 1 / 2 buttons, to select the Coaxial 1 or 2 inputs, ‘CO1’ or ‘CO2’ will appear on the LCD.
c. Press the AUX button to select the Aux input. ‘AU’ will appear on the LCD.
d. Press the ‘FM’ button to select the FM Tuner. The selected frequency will appear on the LCD.
5.1 TEST FUNCTION
1. Press the ‘TEST’ button on the remote control,
this will play a tone through each channel to test
the speakers, the testing sequence is as follows:
2. Press the ‘TEST’ button again to stop the test.
SPEAKER VOLUME LEVEL SELECTION
The speaker volume levels can be individually controlled. e.g..
1. Press the ‘CENTER+’ or ‘CENTER-’ buttons on the remote
control to adjust the volume level of the center speaker, the
speaker volume level will appear on the LCD.
2. The same procedure applies for the other speakers
(SW, FR, FL, RR, RL).
SRS FUNCTION –
Sound Retrieval System
Press the ‘SRS’ button on the remote control, to switch
between ‘SRS-OFF’ and ‘SRS-ON’
VOLUME SELECTION
1. Press the VOLUME + - buttons on the front panel or the MAIN
VOLUME+ - buttons on the remote control to adjust the volume level.
2. The volume level will appear on the front panel LCD and ranges from
00 (minimum) to 63 (maximum).
MUTE
1.
Press the MUTE button on the remote
control to turn the volume OFF
2. ‘---‘ will appear on the front panel LCD
3.
Press the MUTE button again to turn the
volume back ON
Page 5