Operating instructions

DSP FUNCTION – Digital Sound Processing
Press the ‘DSP’ button on the remote control, the front LCD will
display ‘H-1’. The preset equalizers are as follows:
H-1 : LIVE
H-2 : HALL
H-3 : THEATER
H-4 : CHORUS
H-5 : MATRIX
(nb: DSP function is only active for the Auxiliary input and not for the
Optical or Coaxial connections )
MODE FUNCTION
Press the ‘MODE’ button on the remote
control to
select between ‘5.1’ or ‘2.1’
sound outputs.
Input Supports
Optical – 5.1 or 2.1
Coaxial – 5.1 or 2.1
Auxiliary – 2.1 only
5.1 mode
When in ‘5.1’ mode, the input and volume will be
displayed on the front panel
2.1 mode
When in 2.1 mode, ‘2.1’ will be displayed on the
front panel
GETTING THE BEST SOUND QUALITY
In order to get the best sound quality from the SoundStage, we recommend the following:
Listening to Music.
1. When listening to music, connect your audio device to the Aux inputs on the back of the SoundStage.
2. Press the AUX button on the remote control.
3. Press the MODE button and choose 2.1 using the remote control
Watching a Movie
1. When watching a movie, connect the external device to the COAXIAL or OPTICAL inputs on the back of the SoundStage.
2. Select either COAXIAL 1 / 2 or OPTICAL 1 / 2 using the remote control according to your setup.
3. Press the MODE button on the remote control and choose 5.1
FM RADIO
For the best possible FM signal, connect the supplied FM Aerial into the FM ANTENNA connection at the back of the SoundStage.
1. Press the ‘INPUT’ button on the front panel or ‘FM’ on the remote control to select the FM radio function.
2. Press the ‘AUTO’ button on the remote control to select between STEP and SCAN modes.
a. If ‘STEP’ shows on the front display this indicates that you can manually scan for an FM frequency. To manually choose an
FM frequency, press the SCAN  buttons on the remote control.
b. If ‘SCAN’ shows on the front display this indicates that you can automatically scan
for an FM frequency. To automatically
choose an FM frequency, press the SCAN 
buttons on the remote control. The scan will automatically stop when a strong
signal is found.
3. Press the STEREO button on the remote control to switch between stereo and mono sound
Storing a FM frequency
1. Press the SCAN 
buttons on the remote control to select the frequency you wish to store into the memory. Press the ‘MEMORY’
button on the remote control.
2. Press the ‘TU-CH’ buttons on the remote control to select a memory storage location.
3. Press the ‘MEMORY’ button on the remote control to store the selected frequency.
4. You can store up to 20 FM frequencies.
Recalling a FM frequency
5. Press the ‘TU-CH ’ buttons on the remote control to recall a stored frequency
Page 6
DOLBY DIGITAL
When a Dolby Digital source is detected
by the
SoundStage the Dolby Digital logo will appear on the
bottom right side of the front panel