User's Manual
v0.2
Emergency Wall Communicator 3
Installing the Battery
Use the supplied screwdriver to unscrew the battery compartment.
Install the 4 AAA alkaline batteries - alternating them as they are installed.
Note the polarity on the inside of the battery cover. The spring contacts are
meant to touch the negative side of the batteries. Close the battery cover
using the screwdriver provided.
Learning the EWC to the Base unit of Your PERS System.
Note: Throughout this manual - EWC will refer to the Emergency Wall
Communicator; Pendant will refer to a hand-held pendant used by the
Personal Emergency Response System (PERS) - and Base will refer to the
base unit of the PERS system.
On the Base Unit:
1. Push and release the RED Code Learn button on the back of the
Base unit. (Use the tip of the screwdriver or a ball-point pen to reach
through the case). You will hear a voice prompt “Pendant Learning”
On the EWC:
2. PUSH the Gray Battery Test button and the RED Emergency button
simultaneously –HOLD both buttons for a few seconds until you hear
“Pendant Learning” from the EWC - then release both buttons.
• If “Base and Pendant out of Range” is heard from the EWC, stop
- wait 30 seconds and start at step #1 again.
3. When Pendant learning has been successful you will hear “All Systems
are OK” and then it will announce the mode of the Base unit.
TABLE OF CONTENTS
Installing the Batteries ..............................................................................3
Learning the EWC to the Base of Your PERS System ..........................3
Battery Check ............................................................................................4
System Check ............................................................................................5
Warranty ....................................................................................................7
Product Specications ..............................................................................8