User Manual

the SAR

is determined at the highest certified power level, the actual SAR

level of

3G mobile phone while operating can be well below the maximum

value. This is because 3G mobile phone is designed to operate at multiple

power levels so as to use only the power required to reach the network. In

general, the closer you are to a wireless base station antenna, the lower

the power output. Before a 3G mobile phone model is available for sale

to the public, it must be tested and certified to the FCC that it does not

exceed the limit established by the government adopted requirement for

safe exposure. The tests are performed in positions and locations (e.g., at

the ear and and worn on the body) as required by the FCC for each model.

The highest SAR value for this model 3G mobile phone when tested for

worn on the body, as described in this user guide, is 1.40 W/Kg(Body-

worn measurements differ among 3G mobile phone models,

depending upon available accessories and FCC requirements). While

there may be differences between the SAR levels of various 3G mobile

phone and at various positions, they all meet the government

requirement for safe exposure. The FCC has granted an Equipment

authorization for this model Tablet interference will not occur in a

particular installation. If this equipment does cause 3G mobile phone

with all reported SAR levels evaluate as in compliance with the FCC RF

exposure guidelines. SAR information on this 3G mobile phone is on file

with the FCC and can be found under the Display Grant section of http://

www.fcc. gov/ oet/fccid.

FCC ID: TYD-GA30711 Additional information on Specific Absorption

Rates (SAR) can be found on the Cellular Telecommunications Industry

Asso-ciation (CTIA) web-site at http://www.wow-com.com. * In the

United States and Canada, the SAR limit for Tablet PC used by the public

is 1.6watts/kg (W/kg) averaged over one gram of tissue. The standard

incorporates a sub-stantial margin of safety to give additional protection

for the public and to account for any variations in measurements.

Body-worn Operation:

This device was tested for typical body-worn operations. To comply with

RF exposure requirements, a minimum separation distance of 10mm must

be maintained between the user’s body and the handset, including the

antenna. Third-party belt-clips, including the antenna. Third-party belt-

clips, holsters, and similar accessories used by this device should not

contain any metallic components. Body-worn accessories that do not

meet these requirements may not comply with RF exposure requirements

and should be avoided. Use only the supplied or an approved antenna.

v5.1

FCC ID TYD-GA30711

PLUS

UARDIAN

911

LERT