User's Manual




LT‐D‐0211rev16

Page|58


Uponcompletingsettingvaluestoallrelevantparameters,theadministratorcanchoosetosavese ttin gs
totheBase‐StationbypressingtheSETcommand.
Thefollowingmessageshouldappeartoinformtheuserthattheoperationwascompletedsuccessfully:



6.4.8 “TagsSetup”Tab
TheTagsSetuptabprovidesthetooltoconfiguretagswithvariousoperationalparameters,primarilyto
enablevarioussensorsandtunethemtospecificapplications.
SelectingaTagforConfigurationSetup
Inordertoconfigureatag,itmustbeexcitedthroughLFantennaandhavecommunicationwithaUnit:

 Select the Base Station you are about to use for exciting the tag, from the “Select Base Station”
dropdown list. It is recommended to use LogiTag’s technician Hardware for this purpose, as it
includesBase‐StationhardwareandLFantennainasingleenclosure.
 Selecttheantennaportthetagwillinfrontofduringthesetupprocess,fromthe“SelectLocation”
dropdownlist.
 PlacethetaginfrontoftheselectedBase‐Station\Antenna,andpresstheUpdateTagsbutton–the
tag(orseveraltags)shouldappearinthelist.