User's Manual




LT‐D‐0211rev16

Page|55


6.4.5 “Base‐StationSetup”Tab
SelectingaBase‐StationforConfigurationSetup
Withonly1Base‐StationDefined
As soon as switching to the “Base‐Station Setup” tab, the Technician‐Station application will retrieve
fromthesinglebase‐stationcurrentlydefinedthevalueofallparameters,andpopulatesthedatainthe
tab.
Operatorsofthe
applicationsshouldbeawarethatthedataseeninthistabisthedatacurrentlyde fined
intheBase‐Station,andthatanychangeshouldbesavedinordertotakeeffect.
Note–if thevaluesseemsnotbe loadingbyde faultintothe textfields,it  ismost
likelythattheBase‐
Stationissimplywithfactorydefaults,whichareprobablyzerovalues.
Withmorethan1Base‐StationDefined
When switching to the “Base‐Station Setup” tab the Technician‐Station application  will retrieve the
valuesfromtheBase‐Stationdefinedasdefaultinthesystem.
Toretrievevalues
foranother Base‐Stationandenablethem,userscan selectthedesiredBase‐Station
fromthe“BaseStation”dropdownlist.
 